Yamaha AX-892 Owner's Manual - Page 9

English CONNECTING SPEAKERS Connect the SPEAKERS terminals to your speakers with cable of the proper gauge, cut as short as possible. If the speakers are improperly connected, no sound will be heard. Connect each speaker making sure that the polarity (+ and -) is correct. Red: positive (+) Black: negative (-) If the cables are reversed, the sound will be unnatural and will lack bass. Do not allow exposed wires to touch each other or metal parts; this could damage the unit and speakers. q One or two speaker systems can be connected to this unit. If you connect only one speaker system, connect it to either SPEAKERS A or B terminals. q Use speakers with the specified impedance shown on the rear panel. For AX-492's SPEAKERS A and B terminals and for AX-592's SPEAKERS B terminals only: Œ Unscrew the knob.  Insert the exposed wire. [Remove approx. 5 mm (1/4 in) insulation from the speaker wires.] Ž Tighten the knob and secure the wire. 2 1 3 For AX-592's SPEAKERS A terminals only and for AX-892's SPEAKERS A and B terminals: 2 1 3 Banana plug connections are also possible. Simply insert the banana plug connector into the corresponding terminal. (except for UK and Europe models) Œ Unscrew the knob.  Insert the exposed wire. [Remove approx. 5 mm (1/4 in) insulation from the speaker wires.] Ž Tighten the knob and secure the wire. REAR PANEL PARTS AC OUTLETS (SWITCHED) Use these to connect the power cords from your components to this unit. The power to the SWITCHED outlets is controlled by this unit's POWER switch or the remote control's POWER key. These outlets will supply power to the connected components whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the AC OUTLETS (SWITCHED) is 100 watts. 9