Yamaha BBT500H Owner's Manual - Page 17

Attaching the Rack Mount Adaptor Attach the supplied rack mount adaptor lets you install the BBT500H in a standard 19-inch rack. 1. Remove the two screws A on the side of the device and remove the carrying handle set. 2. Remove the two screws B on the side of the device. 3. Attach the supplied rack mount adaptor to the device using the three supplied screws C. * Never use any screws other than the supplied screws C. Using any other screws can result in damage. 4. In the same manner, attach the other supplied rack mount adaptor to the opposite side of the device. 5. Keep the leftover screws (A, B) in a safe place for future use. * Make sure you don't over-tighten the screws when reattaching the carrying handle to the device. Doing so can result in damage to the carrying handle. Carrying Handle Set Rack Mount Adaptor (supplied) B A C Air Flow The device utilizes a forced air cooling system, which cools the interior of the unit by drawing air through the front intake by the fan, which push the air out the back. Intake Side view Front panel Exhaust Rear view Cooling fan q Attaching the Clamp Filter (For U.S. and Canadian models only) To protect against electromagnetic waves, attach the supplied Clamp Filters to the cable connecting the bass guitar to the amplifier's INPUT jack, and the cables connecting the amplifier's SPEAKER 1, 2 jacks to the speakers. * When attaching the clamp filter, wrap the cable once around the clamp filter as close to the BBT500H unit as possible. Cable Clamp Filter Clamp Filter 17