Yamaha BD-A1010 Owners Manual - Page 41
Audio Setting, System Information, SETTINGS, ENTER, RETURN
View all Yamaha BD-A1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
■ Audio Setting The default settings are marked with " * ". Audio Output Coaxial/Optical You can select the output mode of COAXIAL jack and OPTICAL terminal. For more details on output formats, refer to "About the audio output formats" (p. 38). Bitstream Outputs digital signal without any processing. Secondary Audio is not output. PCM Outputs 2-channel PCM. Reencode* Outputs Bitstream with Secondary Audio. Off Mutes sound. HDMI You can select the output mode of HDMI ternminal. For details on setting items, see "Coaxial/Optical" (p. 37). For more details on output formats, refer to "About the audio output formats" (p. 38). Bitstream*, PCM, Reencode, Off Note - To output HD audio (such as Dolby TrueHD or DTS-HD Master Audio) from HDMI terminal, set Resolution to Auto or more than 720p (p. 35). Downsampling You can select digital audio signal down-sample frequency. This function is effective for the audio signal output from the COAXIAL jack/OPTICAL terminal. 48k* The highest sampling rate of digital PCM output is 48 kHz. 96k The highest sampling rate of digital PCM output is 96 kHz. 192k The highest sampling rate of digital PCM output is 192 kHz. DRC You can set the DRC (Dynamic Range Compression) (p. 44) to on/off/Auto. When set to Auto, DRC is automatically turned on for a source with DRC information in Dolby TrueHD format. DRC makes the strong sound such as plosive sound lower, and conversations more audible. It is useful when you watch movies in the night. Off*, On, Auto SACD Output SACD Priority You can select a content played back from multi-channel or stereo (2-channel) contents when a Hybrid SA-CD (p. 4) including both is loaded. Multi-ch*, 2-ch SETUP MENU HDMI Output You can select audio signal output from HDMI terminal when SA-CD is played back. DSD* Outputs DSD raw signal. When this Player is connected to DSD compatible AV receiver, this item is recommended. PCM Outputs PCM signal decoded by this Player. Speaker Setting Configuration 4 You can set the output of 7.1 ch surround depending on the connected speaker or amplifier. SETTINGS 1 Press 5/a to select a speaker you want to configure, then press ENTER. 2 Adjust the figures below. Note that some of items are not displayed depend on the selected speaker. Size When the woofer section of a speaker is 16 cm (6-1/ 2 in) or larger, select Large. When smaller than 16 cm (6-1/2 in), select Small. Large*, Small Trim -12 to 0 dB (in 0.5 dB step) The default setting is 0 dB. Delay 0.5 to 10 m (in 0.5 m step) The default setting is 3 m. Disable When selected speaker is not in use, select Yes. Yes, No* 3 Press RETURN to go back to speaker selection. 2ch Downmix You can select down mix method to analog 2-ch from Stereo or Lt/Rt. Stereo* Changes channel output to stereo, which only delivers sound from the two front speakers. Lt/Rt Select this item if this unit is connected to a Dolby Pro Logic decoder. Sound from rear speakers is mixed to the 2 ch stereo sound. Post Process Up Mix You can multi-channelize the 2-channel audio signal. To multi-channelize, select NEO6, then select Cinema or Music mode. Off*, NEO6 ■ System Information Software version and MAC address (p. 45) are displayed. English 37 En