Yamaha BD-S1065BL Owners Manual - Page 44
Sound, Network, Problem, Possible causes and solutions - black
UPC - 027108934044
View all Yamaha BD-S1065BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Troubleshooting Screen freezes and operation buttons do not work. There is just audio with no video. Video is not output with the desired resolution. Widescreen video appears vertically stretched, or black bands appear at the top and bottom of the screen. 4:3 video appears horizontally stretched Square noise (mosaic) appears on the screen. The playback screen will be disturbed if DVD video is recorded to a VCR, or played back through a VCR. Audio is not output, or images are not played back properly. - Press , then restart playback. - Turn off the power and turn on the power again. - If the power is not turned off, perform a reset. (Page 41) - Is the disc damaged or dirty? Check the condition of the disc. (Page 4) - Is the connection cable for video output connected properly? (Pages 9-11) - Is "Video Out Select" set correctly? (page 31). - Is "Component Video Out" or "HDMI Video Out" set to the desired resolution? (Pages 30-31). - Is "TV Aspect Ratio" set to match the connected TV? (Page 30) - If you are using a widescreen TV, is the "TV Aspect Ratio" set to "Wide"? (Page 30) - If you are using a 4:3 TV, is the "Video Out Select" set to "Component"? (Page 31) - Blocks in images may be visible in scenes with rapid movement due to the characteristics of digital image compression technology. - This Player complies with analog copy protection. Some discs contain a copy prohibiting signal. If you try to play back such discs through a VCR, or record to a VCR and play back the signal, the copy protection will prevent normal playback. (Pages 10- 11) - The audio may not be output or the images may not be played back properly for some discs in which copyright-protected contents are recorded. ■ Sound Problem No sound, or sound is distorted. Left and right channels of audio are reversed, or sound comes out of only one side. Audio is not output, or images are not played back properly. Cannot hear the desired audio type and/ or number of channels. Possible causes and solutions - If the volume of the TV or amplifier is set to minimum, turn the volume up. - There is no sound during still mode, slow motion playback, fast forward and fast reverse. (Page 20) - Check that the audio cable is connected correctly. (Page 12) - Check that the cable plugs are clean. - Take out the disc and clean it. (Page 4) - Audio may not be output depending on the audio recording status, such as when audio other than an audio signal or non-standard audio is recorded for the audio content of the disc. (Page 3) - Are left and right audio cables connected to the opposite terminal, or is one side disconnected? (Page 13) - The audio may not be output or the images may not be played back properly for some discs in which copyright-protected contents are recorded. - Refer to "Audio Out" setting (Page 31) and "About the audio output formats". (Page 38) ■ Network Problem Cannot connect to the Internet. Cannot download BD-LIVE contents. Possible causes and solutions - Is the Network cable connected properly? - Is the wrong cable such as a modular cable used? Connect a Network cable to the NETWORK terminal. (Page 14) - Is the power for the connected equipment, such as broadband router or modem turned on? - Is the broadband router and/or modem properly connected? - Is the proper value(s) set in the network setting? Check "Communication Setup". (Pages 34-36) - Is the LAN cable connected properly? - Is the USB memory device properly connected? Check that the USB memory device is connected to the USB BD STORAGE/SERVICE terminal of this Player. - Check if the BD disc supports BD-LIVE. - Check the setting for "BD Internet Access". (Page 33) 40 En