Yamaha CDC-906 Owner's Manual - Page 24

TRACK PROGRAMMING FOR RECORDING Random Tape Programming The unit will automatically program tracks on a disc in random sequential order for recording to tape. DISC SCAN DISC SKIP REPEAT RANDOM 2 3 1 Follow steps 1 - 3 on page 17. 2 Press the RANDOM button. RANDOM The unit will automatically program tracks for side A and side B separately considering the tape's total time. * The programmed track numbers and the total number of tracks for side A and B are displayed for a short time. 3 Start recording on the tape deck and press the w button at the same time. 4 The unit will pause at the end of side A of the tape. Turn the tape over to side B. Resume recording and, at the same time, press the w or d button. Notes • Because the programmed data changes every time the RANDOM button is pressed, the amount of time remaining at the end of the tape also changes accordingly. • It is recommended that you use a tape that is slightly longer in length than the CD you are recording, because the programmed tracks on a CD may not fit properly into the time allowed on each half of the tape. • CD synchronized recording function can be used if your tape deck is compatible with it. In this case, in steps 3 and 4, press the SYNCHRO button and then press the w button. Recording automatically begins. (For details, refer to page 16.) Display information during programming 3 12345 4 PROG 13 5 7 13:00 1 2 1 Shows the number of programmed tracks for each side in turn just after the automatic programming is finished, and then it is replaced by the number of the first programmed track for side A. 2 Shows the total time of programmed tracks for each side. 3 Shows the programmed track numbers for each side. E-20