Yamaha CVP-309 Owner's Manual - Page 184
Using Your Instrument with Other Devices
View all Yamaha CVP-309 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
Using Your Instrument with Other Devices CAUTION Before connecting the instrument to other electronic components, turn off the power of all the components. Also, before turning any components on or off, make sure to set all volume levels to minimum (0). Otherwise, electrical shock or damage to the components may occur. INPUT VOLUME MIC. LINE IN MIC. LINE PHONES MIN MAX 2 1 1 Using Headphones ([PHONES] jacks) Connect a pair of headphones to one of the [PHONES] jacks (standard 1/4" phone jacks) located on the leftward underside of the instrument. For details, see page 17. 2 Connecting a Microphone or Guitar ([MIC./LINE IN] jack) By connecting a microphone to the [MIC./LINE IN] jack (standard 1/4" phone jack) located on the left underside of the instrument, you can enjoy singing along with Song playback (KARAOKE) or with your own performance. The instrument outputs your vocals or guitar sounds through the built-in speakers. For instructions on connecting, see page 52. Please note that when connecting devices of high output level, make sure to set the [MIC. LINE] switch to "LINE." CVP-309 P. 186 6 P. 189 78 P. 189 P. 189 89 CVP-307 5 4 P. 185 P. 185 P. 186 6 P. 189 78 3 3 P. 189 P. 189 89 345 Connecting Audio & Video Devices n Use audio cables and adaptor plugs having no (zero) resistance. 3 Using External Audio Devices for playback and Recording ([AUX OUT] Jacks, [AUX OUT (LEVEL FIXED)] Jacks, [OPTICAL OUT] Jack) You can connect these jacks to a stereo system to amplify the instrument's sound or to a cassette tape recorder or a digital audio device for recording your performance. The microphone or guitar sound connected to the instrument's [MIC./LINE IN] jack) is output at the same time. Refer to the diagrams below and use audio cables for connection. These jacks are located on the underside jacks panel of the instrument. CAUTION When the instrument's sound is output to an external device, first turn on the power to the instrument, then to the external device. Reverse this order when you turn the power off. Do not route the output from the [AUX OUT] [AUX OUT (LEVEL FIXED)] jacks to the [AUX IN] jacks. If you make this connection, the signal input at the [AUX IN] jacks is output from the [AUX OUT] [AUX OUT (LEVEL FIXED)] jacks. These connections could result in a feedback loop that will make normal performance impossible, and may even damage both pieces of equipment. [AUX OUT] Jacks (Standard phone jacks of [L/L+R] and [R]) When these are connected, you can use the instrument's [MASTER VOLUME] control to adjust the volume of the sound output to the external device. Connect the instrument's AUX OUT [L/L+R]/[R] jacks and the input jacks of a pair of powered speakers using appropriate audio cables. Use only the [L/L+R] jack for connection with a monaural device. Instrument OPTICAL OUT Powered speakers (LEVEL FIXED) L/L+R R L R AUX OUT Phone plug (standard) Audio cable Input jack Phone plug (standard) Using Your Instrument with Other Devices 5 4 P. 185 P. 185 184 CVP-309/307 Owner's Manual 3 3