Yamaha DBR12 Technical Specifications - Page 1
Yamaha DBR12 Manual
View all Yamaha DBR12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
POWERED SPEAKER SYSTEM DBR series ZN19540 Technical Specifications General Specifications General System Type Frequency Range (-10dB) Coverage Angle Crossover Type Crossover Frequency Measured Maximum SPL (Peak) IEC noise@1m Transducer Diameter LF Voice coil Magnet Diaphragm HF Type Magnet Enclosure Material, Color Floor Monitor Angle Dimensions (WxHxD, with rubber feet) Net Weight Handles Pole Socket Rigging Points Optional Seaker Bracket Amplifier Amplifier Type Power Rating *1 Dynamic Continuous Cooling AD/DA HPF/LPF DSP Preset Speaker Protection Amplifier Power Supply Connectors Input Output Input Impedance Input Sensitivity (LEVEL: Maximum) Input Sensitivity (LEVEL: Center) Maximum Input Level Controls Idle Power Consumption 1/8 Power Consumption Power Requirements DBR15 DBR12 2-way, Bi-amp Powered Speaker, Bass-reflex Type 50 Hz-20 kHz 52 Hz-20 kHz H90° x V60° Constant Directivity Horn FIR-X Tuning (Linear Phase FIR Filter) 2.1 kHz 2.1 kHz 132 dB SPL 131 dB SPL DBR15 DBR12 15" Cone 12" Cone 2.5" 2" Ferrite 1.4" 1" Throat Compression Driver Ferrite DBR15 DBR12 Plastic, Black 50° Symmetrical 50° Symmetrical 455 x 700 x 378 mm (17.9" x 27.6" x 14.9") 376 x 601 x 348 mm (14.8" x 23.7" x 13.7") 19.3 kg (42.6 lbs) 15.8 kg (34.8 lbs) Side x 2 35mm Bottom x 2, Rear x 1 (Fit for M8 x 15mm Eyebolts) BBS251, BCS251, BWS251-300, BWS251-400 DBR15 DBR12 Class-D 1000 W (LF: 800 W, HF: 200 W) 465 W (LF: 400 W, HF: 65 W) Fan Cooling, 4 Speeds. 24bit 48kHz Sampling OFF, 100Hz, 120Hz, 24dB/Oct. HPF D-CONTOUR: FOH/MAIN, MONITOR, OFF Clip Limiting, Integral Power Protection, DC-fault Thermal, Output Over Current Thermal, Output Over Voltage, Output Over Current Input1: Combo x1, Input2: Combo x1, RCA PIN x2 (Unbalanced) Output: XLR3-32 x1 (CH1 Parallel Through or CH1+CH2 Mix) INPUT1 (XLR, Phone): 3 kΩ, INPUT2 (XLR, Phone, RCA Pin): 10 kΩ INPUT1: LINE: 0 dBu, MIC: -32 dBu, INPUT2: 0 dBu INPUT1: LINE: +10 dBu, MIC: -22 dBu, INPUT2: +10 dBu INPUT1: LINE: +24 dBu, MIC: -8 dBu, INPUT2: +24 dBu LEVEL x2, LINE/MIC, HPF, D-CONTOUR, THRU/MIX, POWER 18 W 74 W 100 V, 100-120V, 220-240 V, 110/127/220 V (Brazil), 50/60 Hz 0 dBu is referenced to 0.775Vrms. *1 Power Rating (120V, 25°C). This is total value of individual output power. DBR10 55 Hz-20 kHz 2.1 kHz 129 dB SPL DBR10 10" Cone 2" 1" DBR10 50° 308 x 493 x 289 mm (12.1" x 19.4" x 11.4") 10.5 kg (23.2 lbs) Top x 1 Bottom x 2 (Fit for M8 x 15mm Eyebolts) DBR10 700 W (LF: 500 W, HF: 200 W) 325 W (LF: 260 W, HF: 65 W) 18 W 60 W Specifications and descriptions in this owner's manual are for information purposes only. Yamaha Corp. reserves the right to change or modify products or specifications at any time without prior notice. Since specifications, equipment or options may not be the same in every locale, please check with your Yamaha dealer. Block Diagram INPUT Combo (Balance) 1 (MIC/LINE) Combo (Balance) 2 (LINE) Pin LEVEL HA MIC/LINE LEVEL HA SIGNAL HPF 120Hz AD 100Hz OFF (CH1+2 MIX) (CH1 THRU) D-CONTOUR FOH/MAIN OFF MONITOR DSP HF EQ Limiter Mute HF DA Amp. (HF) EQ FIR-X ●LIMIT ●PROTECTION LF LF EQ Delay Limiter Mute DA Amp. (LF) OUTPUT Temp. DC-fault Output Current Output Voltage Integral Output Power On/Off Mute Protection Logic