Yamaha HTR-5490 Owner's Manual - Page 48

REMOTE CONTROL FEATURES Programming a New Remote Control Function (Learn Feature) If you want to program functions not included in the basic operations covered by the manufacturer code, or a manufacturer code is not available, the following procedure needs to be performed. The possible programming area is the same as a component control area, so the buttons are programmable independently for each source component area. Note • This remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of the other remote control's functions. However, you may not be able to program some special signals or extremely long transmissions. (Refer to the operation instructions for the other remote control.) 1 Press an input selector button or Å to select a source component. SYSTEM POWER STANDBY SLEEP 6CH INPUT A PHONO TUNER CD V-AUX CBL/SAT MD/TAPE CD-R D-TV/LD VCR 1 VCR2/DVR DVD VOL - POWER AV POWER TV AMP + AUDIO POWER TV REC DISC SKIP SELECT POWER AV AMP D-TV/LD VCR 1 VCR2/DVR DVD SELECT V-AUX CBL/SAT MD/TAPE CD-R D-TV/LD VCR 1 VCR2/DVR DVD CD PHONO TUNER A V-AUX CBL/SAT MD/TAPE CD-R SLEEP 6CH INPUT STANDBY SYSTEM POWER CD PHONO TUNER RE-NAME CLEAR LEARN TRANSMIT A 4 Press the button for which you want to program the new function. "LEARN" is displayed. 5 Press and hold the button on the other remote control that has the function you want to program into this remote control until "OK" appears in the display window. 6CH INPUT SLEEP STANDBY SYSTEM POWER RE-NAME CLEAR LEARN TRANSMIT POWER AV POWER TV AMP SELECT D-TV/LD VCR 1 VCR2/DVR DVD V-AUX CBL/SAT MD/TAPE CD-R CD PHONO TUNER A SLEEP 6CH INPUT STANDBY SYSTEM POWER RE-NAME CLEAR LEARN TRANSMIT 2 Place this remote control and the other remote control 1 to 4 cm apart on a flat surface so that their infrared transmitters are aimed at each other. 1 to 4 cm (approximately 1 inch) 3 Press LEARN by using a ballpoint pen or similar object. Do not press and hold LEARN longer than three seconds. Otherwise this unit enters the manufacturer code setting mode. LEARN Flashes alternately Note • If you do not press any button within 30 seconds during steps 5 and 6, the learning process is canceled. If this happens, start over from step 4. Notes • "NG" appears in the display window when programming has not been done correctly. In this case, start over from step 4. • This remote control can learn approximately 120 functions. However depending on the signals learned, "FULL" may appear in the display window much earlier than this number. In this case, clear unnecessary programmed functions to make further learning on the remote control. 6 Repeat steps 4 and 5 to program additional functions. 7 Press LEARN again to exit from the learning mode. LEARN Notes • Even if the batteries in the other remote control have enough power to transmit signals for operation, they may not have enough power to transmit signals to this remote control. • When the remote controls are either too close together or too far apart, you may not be able to program this remote control. • Direct sunlight interferes with infrared rays. • "ERROR" appears in the display window when pressing more than one button at once. 44