Yamaha HTR-6080BL MCXSP10 Manual - Page 104
During Auto Setup, After Auto Setup, E-2:no Sur Sp
View all Yamaha HTR-6080BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Troubleshooting During AUTO SETUP Error message Cause Remedy E-1:NO FRONT SP E-2:NO SUR SP E-3:NO PRNS SP E-4:SBR->SBL E-5:NOISY E-6:CHECK SUR. E-7:NO MIC E-8:NO SIGNAL E-9:USER CANCEL E-10:INTERNAL ERROR Front L/R channel signals are not detected. A surround channel signal is not detected. A presence channel signal is not detected. Only a right surround back channel signal is detected. Background noise is too loud. Surround back speakers are connected, though surround L/R speakers are not. The optimizer microphone was unplugged during the "AUTO SETUP" procedure. The optimizer microphone does not detect test tones. The "AUTO SETUP" procedure was cancelled due to user activity. An internal error occurred. Check the front L/R speaker connections. Check the surround speaker connections. Check the presence speaker connections. Connect the surround back speaker to the LEFT SURROUND BACK SPEAKERS terminal if you only have one surround back speaker. Try running "AUTO SETUP" in a quiet environment. Turn off noisy electric equipment like air conditioners or move them away from the optimizer microphone. Connect surround speakers when you use surround back speakers. Connect the supplied optimizer microphone to the OPTIMIZER MIC jack on the front panel. Check the microphone setting. Check the speaker connections and placement. Run "AUTO SETUP" again. Run "AUTO SETUP" again. After AUTO SETUP See page 13 13 13 13 - - 13 28 28 13 28 28 Warning message Cause Remedy W-1:OUT OF PHASE W-2:OVER 24m (80ft) W-3:LEVEL ERROR Speaker polarity is not correct. This message may appear depending on the speakers even when the speakers are connected correctly. The distance between the speaker and the listening position is over 24 m (80 ft). The difference of volume level among speakers is excessive. W-4:CHECK PRNS "EXTRA SP ASSIGN" is set to "PRESENCE", though the presence channel signals are not detected. Check the speaker connections for proper polarity (+ or -). Bring the speaker closer to the listening position. Readjust the speaker installation so that all speakers are set in locations with similar conditions. Check the speaker connections. Use speakers of similar quality. Adjust the output volume of the subwoofer. Check the presence speaker connections. Set "EXTRA SP ASSIGN" to a setting other than "PRESENCE". Notes • If the "ERROR" or "WARNING" screens appears, check the cause of the problem, then run "AUTO SETUP" again. • If a warning message "W-1" appears, corrections are made, but they may not be optimal. • If a warning message "W-2" or "W-3" appears, no corrections are made. • If an error message "E-10" occurs repeatedly, contact a qualified Yamaha service center. See page 13 - - 13 - 28 13 72 100 En