Yamaha MGP32X Owner's Manual - Page 36

Recording/Playing back Playing back songs from an iPod/ iPhone Connecting your iPod or iPhone to the unit lets you play back the song. NOTE You cannot make recordings to an iPod or iPhone. 1. Use a USB cable to connect your iPod (or iPhone) to the iPod/iPhone IN connector. When the iPod or iPhone is connected to and recognized by the unit, the iPod indicator lights. iPod/iPhone IN connector Lit 2. Specify the output assignment for playback.  To output to the STEREO bus Set the TO STEREO/TO MONITOR switch in the iPod IN section to "TO STEREO" ( ). 3. Operate the iPod (or iPhone) to play back the desired song. 4. Adjust the volume of the song.  When outputting to the STEREO bus or to MONITOR OUT Rotate the iPod IN knob to adjust the volume.  When outputting to channels 31/32 {23/24} Use the channel fader to adjust the volume. NOTE Avoid adjusting both outputs at the same time because of the delay of the signal path. 5. Operate the iPod (or iPhone) to stop the song. Playback stops. Specifying the recording/playback settings 1. Press the USB button below the display repeatedly if necessary until the (3/3) PARAMETER page appears. Set to TO STEREO ()  To output to MONITOR OUT Set the TO STEREO/TO MONITOR switch in the iPod IN section to "TO MONITOR" ( ).  To output to channels 31/32 {23/24} Set the input select switch for channels 31/32 {23/24} to "iPod IN" ( ). Set to iPod IN ( ) NOTE Do not use both the STEREO/MONITOR level control (USB IN knob) and the level control for channels 31/32 {23/24} at the same time. Raising both may cause unnatural flanging in the sound. 36 MGP32X/MGP24X Owner's Manual 2. Rotate Knob 1 to select the desired parameter, and then rotate Knob 2 to set the parameter value. Each parameter lets you make the following settings. Parameter name RecSource Rec Level Rec Form PB Level PB Mode iPodLevel Content Parameter value/ range Selection of the record- STEREO, ing signal source MATRIX1/2 Adjustment of the recording level -48dB to +24dB Selection of the recording format type MP3:128k, 192k, 256k, 320k, WAV * "k" is an abbrevia- tion for "kbps." Adjustment of playback level -48dB to 0dB Selection of playback mode One, All, Repeat One, Repeat All Adjustment of the input level from the iPod or iPhone -48dB to 0dB NOTE Since high transmission speed is required for recording formats such as WAV and MP3:320k, some USB devices may not be able to record songs. In this case, change the recording format to a format with a high compression rate, such as MP3:128k, MP3:192k, or MP3:256k.