Yamaha MY4-AEC MTX5-D/MY4-AEC System Setup Manual
Yamaha MY4-AEC Manual
 |
View all Yamaha MY4-AEC manuals
Add to My Manuals
Save this manual to your list of manuals |
Yamaha MY4-AEC manual content summary:
- Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 1
about the details, and refer to the "MTX Editor User's Manual" (PDF file) about the details of MTX Editor. Special Notice • The software and this manual are the exclusive copyrights of Yamaha Corporation. • Copying of the software or reproduction of this manual in whole or in part by any means is - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 2
. For detailed parameter settings, refer to "MTX Editor User's Manual." When you install MTX Editor, the four example files described here will be found in the following folders. 32-bit operating system C:\Program Files\Yamaha\MTX Editor\V*.*\ProjectFile 64-bit operating system C:\Program Files - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 3
room Introduction Microphone 1 Microphone 2 Microphone 3 Microphone 4 Analog IN Analog OUT XMV4140 YDIF MTX5-D Meeting room CODEC Analog IN/OUT Network Remote A This is an example of one remote details on this example, refer to page 7 and following. MTX5-D/MY4-AEC System Setup Manual 3 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 4
Microphone 5 Microphone 6 Microphone 7 Microphone 8 Analog OUT Meeting room XMV4140 Analog IN YDIF MTX5-D Analog IN/OUT CODEC Network Remote A This is an example of one remote location with . For details on this example, refer to page 11 and following. MTX5-D/MY4-AEC System Setup Manual 4 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 5
. Use the AEC 4Mic 4RemoteLocation-*.mtx file. This example assumes that you're using the following equipment. • MTX5-D 1 • MY4-AEC 1 • XMV4140 (Amplifier) 1 • Microphones (Boundary microphones) For details on this example, refer to page 15 and following. MTX5-D/MY4-AEC System Setup Manual 5 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 6
Use the AEC 2MeetingRoom 2RemoteLocation-*.mtx file. This example assumes that you're using the following equipment. • MTX5-D 1 • MY4-AEC 1 • XMV4140 (Amplifier) 1 • Microphones (Boundary microphones) on this example, refer to page 19 and following. MTX5-D/MY4-AEC System Setup Manual 6 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 7
below. Microphone 1 Microphone 2 Microphone 3 Microphone 4 Analog IN Analog OUT XMV4140 YDIF MTX5-D Meeting room CODEC Analog IN/OUT Network Remote A In this example, the signal flow FEVoice: Far-end Voice TO FE: To Far-end NR: Noise Reduction MTX5-D/MY4-AEC System Setup Manual 7 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 8
set up. Echo cancellation will no longer work effectively if you do so. In this example, the connections are as follows. Microphone Microphone Microphone Microphone 4 3 2 1 MTX5-D (UNIT ID=01) Computer Network Switch XMV4140 (UNIT ID=30) ON 12345678 O N RECORDER CODEC - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 9
. For details on how to make this setting, refer to the "MTX Editor User's Manual." NOTE FBS is also provided by the MY4-AEC; however, because the FBS of the MTX5-D allows more flexible settings, you should use the FBS of the MTX5-D. • To make echo cancellation work effectively Do not use GATE, COMP - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 10
to connect recording/playback device To record, connect your device to the MTX5-D's "OUTPUT" 7 connector. To play back, connect your device to the MTX5-D's "ST IN" 2L connector. When recording, turn on the [ON it off. When playing back, turn this button back on. MTX5-D/MY4-AEC System Setup Manual 10 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 11
6 Microphone 7 Microphone 8 Analog OUT Meeting room XMV4140 Analog IN YDIF MTX5-D Analog IN/OUT CODEC Network Remote A In this example, the signal ZONE 9 1 ch ZONE 1 1 ch OutputCh 1 ch XMV 2 YDIF 1 (A ch) OutputCh 1 ch 1 CODEC ([OUTPUT] 1) MTX5-D/MY4-AEC System Setup Manual 11 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 12
work effectively if you do so. In this example, the connections are as follows. Microphone Microphone Microphone Microphone 4 3 2 1 MTX5-D (UNIT ID=01) RECORDER CODEC Computer Network Switch XMV4140 (UNIT ID=30) Microphone Microphone Microphone Microphone 8 7 6 5 O N ON 12345678 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 13
. For details on how to make this setting, refer to the "MTX Editor User's Manual." NOTE FBS is also provided by the MY4-AEC; however, because the FBS of the MTX5-D allows more flexible settings, you should use the FBS of the MTX5-D. • To make echo cancellation work effectively Do not use GATE, COMP - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 14
to connect recording/playback device To record, connect your device to the MTX5-D's "OUTPUT" 7 connector. To play back, connect your device to the MTX5-D's "ST IN" 2L connector. When recording, turn on the [ON it off. When playing back, turn this button back on. MTX5-D/MY4-AEC System Setup Manual 14 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 15
1 Microphone 2 Microphone 3 Analog IN Microphone 4 Analog OUT Meeting room XMV4140 CODEC A YDIF MTX5-D Analog IN/OUT CODEC B CODEC C CODEC D Network Remote A Network Remote B Network : Far-end Voice TO FE: To Far-end NR: Noise Reduction MTX5-D/MY4-AEC System Setup Manual 15 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 16
set up. Echo cancellation will no longer work effectively if you do so. In this example, the connections are as follows. Microphone Microphone Microphone Microphone 4 3 2 1 MTX5-D (UNIT ID=01) RECORDER Computer Network Switch XMV4140 (UNIT ID=30) ON 12345678 CODEC D CODEC C CODEC B CODEC - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 17
. For details on how to make this setting, refer to the "MTX Editor User's Manual." NOTE FBS is also provided by the MY4-AEC; however, because the FBS of the MTX5-D allows more flexible settings, you should use the FBS of the MTX5-D. • To make echo cancellation work effectively Do not use GATE, COMP - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 18
to connect recording/playback device To record, connect your device to the MTX5-D's "OUTPUT" 7 connector. To play back, connect your device to the MTX5-D's "ST IN" 2L connector. When recording, turn on the [ON it off. When playing back, turn this button back on. MTX5-D/MY4-AEC System Setup Manual 18 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 19
two meeting rooms and conferencing with separate locations Microphone 1 Microphone 2 Microphone 3 Microphone 4 Analog IN Analog OUT XMV4140 YDIF MTX5-D Meeting room 'A' CODEC A Analog IN/OUT Network Remote A Microphone 1 Microphone 2 Microphone 3 Microphone 4 Analog OUT Meeting room - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 20
) and adjusting the parameters of an operating system after it has been set up. Echo cancellation will no longer work effectively if you do so. MTX5-D/MY4-AEC System Setup Manual 20 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 21
conferencing with separate locations In this example, the connections are as follows. Meeting room 'A' Microphone Microphone Microphone Microphone 4 3 2 1 MTX5-D (UNIT ID=01) RECORDER B RECORDER A Computer Network Switch XMV4140 (UNIT ID=30) Microphone Microphone Microphone Microphone - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 22
. For details on how to make this setting, refer to the "MTX Editor User's Manual." NOTE FBS is also provided by the MY4-AEC; however, because the FBS of the MTX5-D allows more flexible settings, you should use the FBS of the MTX5-D. • To make echo cancellation work effectively Do not use GATE, COMP - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 23
" screen. • If you want to connect recording/playback device For recording, connect your device to the MTX5-D's "OUTPUT" 2 connector and 5 connector (2 is meeting room 'A', and 5 is meeting room 'B'). For playback it off. When playing back, turn this button back on. MTX5-D/MY4-AEC System Setup Manual 23 - Yamaha MY4-AEC | MTX5-D/MY4-AEC System Setup Manual - Page 24
in the remote location. Reduces steady-state noise from sources such as a projector or air conditioning unit in the local location. C.S.G., PA Development Division © 2013 Yamaha Corporation 312PO-A0 MTX5-D/MY4-AEC System Setup Manual 24
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
MTX5-D/MY4-AEC System Setup Manual
1
By using the MTX5-D and the MY4-AEC, you can configure a remote conferencing system. Please
read this manual when you want to configure a remote conferencing system using the MTX5-D and
the MY4-AEC. This manual provides a simple explanation of the setup procedure, using the project
file that is preinstalled in MTX Editor. Understanding how the inputs and outputs of the MTX5-D
and the MY4-AEC are related will allow you to configure a system that meets your needs.
Please refer to the owner’s manual on devices about the details, and refer to the “MTX Editor
User’s Manual” (PDF file) about the details of MTX Editor.
Special Notice
• The software and this manual are the exclusive copyrights of Yamaha Corporation.
• Copying of the software or reproduction of this manual in whole or in part by any means is expressly forbidden without the written consent of
the manufacturer.
•
Yamaha makes no representations or warranties with regard to the use of the software and documentation and cannot be held responsible for
the results of the use of this manual and the software.
• Future upgrades of application and system software and any changes in specifications and functions will be announced at the following web-
site.
• The screen displays as illustrated in this manual are for instructional purposes, and may appear somewhat different from the screens which
appear on your computer.
• Windows is a registered trademark of Microsoft® Corporation in the United States and other countries.
• The company names and product names in this manual are the trademarks or registered trademarks of their respective companies.
MTX5-D/MY4-AEC
System Setup Manual
EN