Yamaha NP-32 NP-32/NP-12 Owners Manual - Page 22
Troubleshooting
View all Yamaha NP-32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Troubleshooting Problem Cause Solution When the instrument is turned on or off, a This is normal and indicates that the instrument is - popping sound is temporarily produced. receiving electrical power. The instrument does not turn on. The plugs are not properly connected. Securely connect the AC adaptor to the DC IN jack on the instrument and to the AC outlet (page 12). The batteries are low or dead. Use either new batteries or recharged Ni-MH batteries, or use the included AC adaptor (page 12). Power suddenly and unexpectedly turns off. This is normal and the Auto Power Off function may - have been activated (page 21). When the instrument is turned on, the power If an AC adaptor other than the one specified is used, - turns off suddenly and unexpectedly. the power may be turned off suddenly and unexpectedly. Noise is heard from the instrument's speakers or headphones. The noise may be due to interference caused by the Turn off the mobile phone, or use it further away from the instrument. use of a mobile phone in close proximity to the instrument. The batteries are low or dead. Use either new batteries or recharged Ni-MH batteries, or use the included AC adaptor (page 12). The overall volume is low, or no sound is heard. The volume is set too low. A pair of headphones or conversion adaptor is connected to [PHONES/OUTPUT]. Turn up the volume (page 10). Disconnect the pair of headphones or conversion adaptor (page 11). Local Control is off. Turn Local Control on (see the Online Manual "MIDI Reference"). The batteries are low or dead. Use either new batteries or recharged Ni-MH batteries, or use the included AC adaptor (page 12). The sound is distorted. You are using manganese batteries. Turn down the volume, or use either new batteries or recharged Ni-MH batteries, or use the included AC adaptor (page 12). The pitch and/or tone of the piano Voices in This is normal and is a result of sampling algorithms. - certain ranges do not sound right. The sustain pedal has no effect. The pedal cable/plug may not be properly connected. Make sure to securely insert the pedal plug into [SUSTAIN] (page 11). The footswitch/foot pedal seems to produce The polarity is reversed because the footswitch/foot Turn the power off and turn it on again to reset the function (page 11). the opposite effect. pedal was pressed when the power was turned on. Noise is heard from the instrument's - speakers or headphones when using the instrument with the application on iPhone/ iPad/iPod touch. When you use the instrument along with the application on your iPhone/ iPad/iPod touch, we recommend that you set "Airplane Mode" to "ON" on your device. 22 NP-32/NP-12 Owner's Manual