Yamaha NS-C5HX Owner's Manual - Page 4

REMOVING THE FRONT COVER, Maximum Input Power

Page 4 highlights

REMOVING THE FRONT COVER The front cover is fastened to the enclosure at four points and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four pegs on the speaker with the four corresponding holes on the inside surface of the cover and push gently. Note When the cover is removed, take care not to touch the speaker units with your hands or to exert excessive force with tools. SPECIFICATIONS Type 2-way 3-speaker acoustic suspension speaker system Magnetic shielding type Driver 13 cm (5") cone woofer x 2 Wave guide horn 3 cm (1") dome tweeter Impedance 6 Ω Frequency Response 55 Hz to 50 kHz Nominal Input Power 100 W Maximum Input Power 300 W Sensitivity 91 dB/2.83 V/m Crossover Frequency 2.5 kHz Dimensions (WxHxD 500 x 186 x 257 mm (19-11/16" x 7-5/16" x 10-1/8") Weight 11.5 kg (25 lbs. 6 oz.) G Specifications subject to change without notice due to product improvements. G Care should be taken not to exceed the input power values noted above. E-4

  • 1
  • 2
  • 3
  • 4
  • 5

E-
4
SPECIFICATIONS
Type
.......................
2-way 3-speaker acoustic suspension
speaker system
Magnetic shielding type
Driver
.......................................
13 cm (5
) cone woofer x 2
Wave guide horn 3 cm (1
) dome tweeter
Impedance
...................................................................
6
Frequency Response
................................
55 Hz to 50 kHz
Nominal Input Power
................................................
100 W
Maximum Input Power
..............................................
300 W
Sensitivity
...................................................
91 dB/2.83 V/m
Crossover Frequency
.............................................
2.5 kHz
Dimensions (WxHxD)
.........................
500 x 186 x 257 mm
(19-11/16
x 7-5/16
x 10-1/8
)
Weight
..............................................
11.5 kg (25 lbs. 6 oz.)
Specifications subject to change without notice due to
product improvements.
Care should be taken not to exceed the input power
values noted above.
REMOVING THE FRONT COVER
The front cover is fastened to the enclosure at four points
and can be removed if desired. To remove the cover, hold
on to both sides and slowly pull straight away from the
speaker. To reattach, line up the four pegs on the speaker
with the four corresponding holes on the inside surface of
the cover and push gently.
Note
When the cover is removed, take care not to touch the
speaker units with your hands or to exert excessive
force with tools.