Yamaha NS-E120 Owner's Manual

Yamaha NS-E120 Manual

Get Yamaha NS-E120 PDF manuals and user guides View all Yamaha NS-E120 manuals
Add to My Manuals
Save this manual to your list of manuals

Yamaha NS-E120 manual content summary:

  • Yamaha NS-E120 | Owner's Manual - Page 1
    Natural Sound Bass-Reflex Type Effect Speaker System Thank you for selecting this Yamaha NS-E120 speaker system. This model is designed mainly to be used as an effect speaker system. PRECAUTIONS Read these precautions carefully before operating your speakers. • When using an amplifier with a rated
  • Yamaha NS-E120 | Owner's Manual - Page 2
    may be attached to a wall by using the hooks provided on the speakers' back panels. Fasten wood screws into a firm wall or wall support as shown in the diagram, and hang the speaker hooks on the protruding screws. ∅4-5 mm MIN. 12 mm 4 mm Tapping screw (Available at the market) WARNING: * Each
  • 1
  • 2
NS-E120
Natural Sound Bass-Reflex
Type Effect Speaker System
Thank you for selecting this Yamaha NS-E120
speaker system.
This model is designed mainly to be used as an effect
speaker system.
PRECAUTIONS
Read these precautions carefully before operating
your speakers.
• When using an amplifier with a rated output power
higher than the music input of the speakers, care
should be taken never to exceed the speakers’
music input.
• Do not attempt to clean the speakers with chemical
solvents as this might damage the finish. To clean,
wipe with a dry, soft cloth.
• To prevent the enclosure from warping or
discoloring, do not place the speakers where they
will be exposed to direct sunlight or excessive
humidity.
• Do not place the speakers where they are liable to
be knocked over or struck by falling objects. Stable
placement will also ensure better sound
performance.
• Placing the speakers on the same shelf or rack as
the turntable can result in feedback.
• As these speakers contain strong magnets, avoid
placing watches, magnetic tapes, etc. near them.
Also, placing the speakers near a TV set may
impair picture color. If this happens, move the TV
set away from the speakers.
•
Secure installing is the owner’s responsibility.
YAMAHA shall not be liable to any accident caused
by a failure in installing at a proper position and by
proper installation procedure.
CONNECTION TO
YOUR AMPLIFIER
BEFORE MAKING CONNECTIONS, MAKE SURE
THAT THE AMPLIFIER IS SWITCHED OFF.
m
CONNECTIONS
• Connect the push-type input terminals at the rear of
the speakers to the speaker output terminals of your
amplifier with the supplied speaker cables.
• One side of the speaker cable is marked by a white
line. Connect the (+) terminals on both the amplifier
and the speakers using this white-marked side.
Connect the (–) terminals on both components
using the unmarked side of the cable.
•
Connect the left speaker to the left (marked L)
terminals of your amplifier, and the right speaker to
the right (marked R) terminals, making sure not to
reverse the polarity (+, –). If one speaker is
connected with reversed polarity, the sound will be
unnatural and lack bass.
Procedures:
1
Press the tab on the terminal down, as shown in
the figure.
2
Insert the bare wire end properly into the terminal.
3
Remove your finger from the tab to allow it to lock
snugly on the cable’s wire end.
4
Test the security of the connection by tugging
lightly on the cable at the terminal.
Press tab
White line
Speaker output
terminals of the
amplifier
White line
White line
Right speaker
Left speaker