Yamaha NS-F700 Owners Manual - Page 6

ATTACHING THE FRONT COVER The speaker and the front cover are packed separately. To attach the front cover, line up the projections (magnets) on the reverse side of the front cover with their corresponding screw heads on the speaker. SPECIFICATIONS Type 3-way bass reflex speaker system Non-Magnetic shielding type Driver 16 cm (6.5") cone woofer × 1 Advanced PMD 13 cm (5") cone mid-range × 1 Advanced PMD 3 cm (1") aluminum dome tweeter DC diaphragm Impedance 6 Ω Frequency Response 45 Hz to 50 kHz (-10 dB) Nominal Input Power 40 W Maximum Input Power 160 W Sensitivity 89 dB/2.83 V/m Crossover Frequency 700 Hz/4 kHz Dimensions (with stands)(W × H × D) .. 354 × 1012 × 374 mm (13-15/16" × 39-13/16" × 14-3/4") Weight 25 kg (55 lbs. 2 oz.) • Specifications subject to change without notice due to product improvements. • Care should be taken not to exceed the input power values noted above. • A speaker cable is not included with this model. Notes • When removing the cover, be careful that you don't touch the drive units, and don't exert excessive force with any tools. • There are magnets on the reverse side of the front cover. Do not place the front cover close to objects that might be affected by magnets, such as CRT TV, clock, magnetic card, diskette, etc., after removing it. Taking care of the speaker When you wipe this unit, do not use chemical solvents (e.g., alcohol or thinners, etc.): this might damage the finish. Use a clean, dry cloth. For difficult soils, dampen a soft cloth in detergent diluted with water, wring it out, and then wipe with the cloth. 4 En