Yamaha NS-U40P Owner's Manual - Page 4

Ⅵ Mounting the speakers on a wall The speakers can also be hung on the wall. Fasten screws into a firm wall or wall support as shown in the figure, and hang the slits on the rear of the speaker on the protruding screws. * Make sure that the screws are securely caught by the slits. Tapping screw (4 mm) (Available in hardware stores) Note Do not place the speaker on top of the monitor with an inclination of more than 10 degrees. 10؇ 10؇ 4 mm Min. 20 mm 50 mm Warning ● Each speaker weighs 0.3 kg (0.6 lbs.). Do not mount them on thin plywood or a wall with soft surface material. If mounted, the screws may come out of the flimsy surface and the speakers may fall. This could damage the speakers and cause personal injury. ● Do not install the speakers on a wall with nails, adhesives, or any other unstable hardware. Long-term use and vibrations may cause them to fall. ● To avoid accidents resulting from tripping over loose speaker cables, fix them to the wall. Wall/ wall support Placing the center speaker on top of the monitor with the speaker stand attached to the speaker In this method, you need to fix the speaker cable on the monitor by using the provided cable holder to prevent the speaker from falling. 1 Remove the backing sheet from the holder, and attach the holder on top of the monitor by pressing it down forcibly. (The top of the monitor must be cleaned beforehand.) Cable holder Ⅵ Placing the center speaker on top of the monitor A speaker used for the center speaker can be placed on top of the monitor. Follow one of the two procedures below for placing a speaker on top of the monitor. Placing the center speaker on top of the monitor by using the provided fastener First remove the stand from the speaker, and attach the provided fastener at the bottom of the speaker and on top of the monitor to prevent the speaker from falling. * This is the recommended method for placing a speaker on top of the monitor. If discoloration of picture occurs, or you need the speaker stand to adjust the speaker angle on top of the monitor, you can select the following method. Fastener 2 Tie the speaker cable to the holder firmly with a provided vinyl-coated wire (which is originally used for bundling the speaker cables) as shown below. Vinyl-coated wire Note Though this speaker is a magnetically shielded type, there may be some influence on the monitor picture depending on the type of monitor or the placement of the speaker. In such a case, place the speaker further apart from the monitor until there is no influence on the monitor picture. E-2