Yamaha PAC112J Owners Manual - Page 6
VIBRATO SYSTEM, Locking Type part 1 - guitar
UPC - 086792646749
View all Yamaha PAC112J manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
VIBRATO SYSTEM Locking Type (part 1) When changing strings it is necessary to cut off the ball ends of the strings. Following is the procedure for changing strings and adjusting the vibrato system: 7) Lock the strings above the nut. (illustration - A) 8) Use the fine tuning thumb screw to tune the guitar to the correct pitch. (illustration - C) 1) Using the supplied hexagonal wrench, loosen the three hexagonal screws on the lock above the nut. (illustration - A) 2) Loosen the individual string locks using the supplied hexagonal wrench. (illustration - B) 3) Replace the old strings with new strings. 4) Using the hexagonal wrench, lock each string. (illustration - B) After locking the strings, make sure that the fine tuning thumb screws are in the middle of their range of travel. (illustration - C) 5) Tune the guitar to the correct pitch. 6) Remove the back plate to gain access to the vibrato strings. Three springs are factory installed and we recommend that these springs be adjusted so that the vibrato bridge plate is parallel to the top of the guitar when it is tuned to correct pitch. 6 Loosen A Tighten @F@H@PN@FOJOEE