Yamaha QL5 Firmware Update Guide - Page 12

Dante Firmware Update Manager], Now recovery and firmware update are completed.

Get Yamaha QL5 PDF manuals and user guides View all Yamaha QL5 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

7. Select [Start]→[All programs]→[Audinate]→[Dante Firmware Update Manager]→[Dante Firmware Update Manager ] , then right-click and select "Run as Administrator." The Dante Firmware Update Manager will start up. ・ When running under Windows 7, the "User Account Control" dialog box may appear. Click [Continue] or [Yes]. 8. If you see the interface selection screen, select the interface card to connect the Dante device. 9. Click [Failsafe Recovery]. 10. Check the detected QL. 11. Click [Start]. A pop-up is displayed confirming that you wish to proceed. 12. Click [OK] to start the recovery. Firmware Update Manager will display "Processing Safe Recovery", and then "Safe recovery Done" when the device(s) are recovered. 13. Exit the Dante Firmware Update Manager, and wait for two minutes before turning off the power to the QL main unit. 14. The correct Dante firmware now needs to be loaded. Follow steps 2 through 9 described in "Updating the Dante firmware." Now recovery and firmware update are completed. QL5/QL1 Firmware Update Guide C.S.G., PA Development Division © 2014 Yamaha Corporation A0 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
QL5/QL1 Firmware Update Guide
12
7.
Select [Start]
→
[All programs]
→
[Audinate]
→
[Dante Firmware Update Manager]
→
[Dante Firmware
Update Manager ] , then right-click and select “Run as Administrator.”
The Dante Firmware Update Manager will start up.
・
When running under Windows 7, the "User Account Control" dialog box may appear. Click [Continue] or
[Yes].
8.
If you see the interface selection screen, select the interface card to connect the Dante device.
9.
Click [Failsafe Recovery].
10.
Check the detected QL.
11.
Click [Start].
A pop-up is displayed confirming that you wish to proceed.
12.
Click [OK] to start the recovery.
Firmware Update Manager will display "Processing Safe Recovery", and then "Safe recovery Done" when the
device(s) are recovered.
13.
Exit the Dante Firmware Update Manager, and wait for two minutes before turning off the power to
the QL main unit.
14.
The correct Dante firmware now needs to be loaded.
Follow steps 2 through 9 described in "Updating the Dante firmware."
Now recovery and firmware update are completed.
C.S.G., PA Development Division
© 2014 Yamaha Corporation
A0