Yamaha YAS 71 Owner's Manual - Page 13

PREPARATION PLACING THIS SYSTEM ■ Attaching the center system to a wall Installing the center system using the keyholes You can attach the center system to a wall using commercially available screws (#8, Diameter: 7.5 mm or more (5/16" or more)). When installing the center system on a wall, all installation work must be performed by a qualified contractor or dealer. The customer must never attempt to perform this installation work. Improper or inadequate installation could cause the center system to fall, resulting in personal injury. 1 Attach the supplied mounting template on a wall and mark the holes of the mounting template. Tapes or thumbtacks Mark Installing the cables above the center system To pass the cables upward, you need to attach the spacers to make room on the back of the center system. 2 Remove the mounting template and then install the commercially available screws at the marks. Diameter: 7.5 mm or more (#8, 5/16" or more) 4 to 6 mm (3/16" to 1/4") y To install the cables above the center system, refer to the right column. 3 Hang the center system on the screws using the keyholes on the back of the center system. In step 2 of the left column; 2-a: Attach the supplied spacers to the rear panel of the center system using the supplied double-sided tapes. You can choose either the side A or the side B. A: For narrow space Double-sided tape B: For wide space Double-sided tape Attach Attach 2-b: Remove the mounting template and then install the commercially available screws at the marks. 22 to 24 mm (7/8" to 15/16") 34 to 36 mm (1-5/16" to 1-7/16") English 9 En