Yamaha YCH-585 Owner's Manual - Page 3

ASSEMBLY PROCEDURE 1 Insert the side columns into the base. At this time, make sure that the damper rest, attached at the center of the column, and the short section of the column is positioned upright. Side Column Damper Rest Short Section Long Section 3 Remove the damper stay, attached to the bottom of the damper, loosen the wing bolt on the damper stay, and attach the stay to the pedal hook. The pedal's position can be controlled by adjusting the length of the pedal stay with its two wing bolts. At this time, tighten the upper wing bolt first, then go on to tighten the lower bolt. Adjust the pedal position so that the pedal stops slightly above the floor when fully depressed. Damper Stay Base Base Pedal Hook 4 Slide the hanger onto the side columns. 2 Fit the damper onto the side columns and lower the damper onto the damper rest. Next, secure the damper in its position with the damper wing bolts. At this time, tighten the wing bolts that secure the side column to the base as well. Hanger Side Column Damper Damper Stay Side Column Damper Rest