Yamaha YDP-103 YDP-103 Owners Manual - Page 23

2-5 Securely tighten the screws on the top of B that were attached in Step 2-2. 2-2, 2-5 E B 2-3 D 2-1 Place the bottom ends 2-4 of the rear panel on each foot. 2-3 3. Secure C. Securely tighten the screws on C that were attached in Step 1-3. Keyboard Stand Assembly CAUTION • Fingers can become pinched between the main unit and the rear or side panels, be extra careful so as not to drop the main unit. • Do not hold the keyboard in any position other than the position shown in the illustration. 5. Secure A. 5-1 Adjust the position of A so that the left and right ends of A will project beyond D and E equally when seen from the front. 5-2 Secure A by tightening the short screws  (6 x 16 mm) from the front. 5-1 Projection of A D B E C 5-2 3 4. Mount A. Be sure to place your hands at least 10 cm from either end of A when positioning it. At least 10 cm A E At least 10 cm B D 6. Connect the pedal cord and the AC adaptor. 6-1 Insert the pedal cord plug to the [TO PEDAL] jack from the rear. 6-2 Securely wind the cord holder around the pedal cord. The cord holder is attached to D. 6-3 Insert the AC adaptor plug into the DC IN jack from the rear. 23 YDP-103 Owner's Manual