Yamaha YDP-105 YDP-105 Owners Manual - Page 18
power plug., Rotate the adjuster until it presses
View all Yamaha YDP-105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Keyboard Stand Assembly 5. Secure the main unit by tightening the thick screws (6 × 16 mm). Main unit Side board (R) 6-1 Insert the pedal cord plug to the [TO PEDAL] jack from the rear. Insert the plug until the metal part disappears from view. Metal part Side board (L) × 4 Thick screws (6 × 16 mm) 6. Connect the pedal cord plug and the power plug. 6-2 Cord holder 6-1 TO PEDAL 6-3 DC IN NOTICE If it is not plugged in firmly, it may cause the pedals to not work. 6-2 Wind the cord holders around pedal cord to hold it. The cord holders are attached to the side board (L). 6-3 Insert the DC plug into the DC IN jack. 7. Rotate the adjuster until it presses in firm contact with the floor surface. Make sure that the pedal box does not rattle or give way when you step on the pedals. 18 YDP-105 Owner's Manual To press against the floor To separate from the floor After completing the assembly, please check the Postassembly checklist (page 16).