Yamaha YDP-184 YDP-184 Owners Manual - Page 105
Set the adjuster., Attach the headphone hanger., pedal cord.
View all Yamaha YDP-184 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Keyboard Stand Assembly 5-1. Insert the plug of the pedal cord into the pedal connector. Insert the pedal cord securely PEDAL until the metal part of the cord plug disappears from view. Otherwise, the pedal may not function properly. 5-2. Attach the cord holders to the rear panel as shown, then clip the cord into the holders. 5-3. Use a vinyl tie to take up any slack in the pedal cord. 5-4. Connect one end of the power cord to the AC adaptor. 7. Attach the headphone hanger. Use the two thin screws (4 × 10 mm) to attach the hanger as shown in the illustration. 5-5. Insert the DC plug of the AC adaptor into the DC IN jack. 6. Set the adjuster. Rotate the adjuster until it comes in firm contact with the floor surface. Transporting If you move to another location, you can transport the instrument along with other belongings. You can move the unit as it is (assembled) or you can disassemble the unit down to the condition it was in when you first took it out of the box. Transport the keyboard horizontally. Do not lean it up against a wall or stand it up on its side. Do not subject the instrument to excessive vibration or shock. When transporting the assembled instrument, make sure all screws are properly tightened and have not been loosened by moving the instrument. 105 YDP-184 Owner's Manual