Yamaha YDP-S34 YDP-S34_Owners Manual_EN - Page 32

Keyboard Stand Assembly E 2-1, 2-4 B D 2-2 2-3 2-2 Secure the anti-fall brackets () using the screws. CAUTION Be sure to attach the anti-fall brackets to the instrument, to ensure stability. Failure to do so might result in damage to the instrument or even injury. 3. Secure C. 3-1 Securely tighten the screws on C that were attached in Step 1-3. 3-2 Attach the caps () to the head of the screws. 3-2 CAUTION • Be careful not to pinch your fingers or drop the unit. • Make sure to keep your hands more than 10 cm distant from the ends of A when positioning the unit, to avoid pinching your fingers. • Do not hold the keyboard in any position other than the position shown in the illustration. 5. Secure A. 5-1 Adjust the position of A so that the left and right ends of A will project beyond D and E equally when seen from the front. 5-2 Secure A by tightening the short screws  (6 x 16 mm) from the bottom. 5-1 A Projection of A A D B E C 3-1 4. Mount A. Be sure to place your hands at least 10 cm from either end of A when positioning it. At least 10 cm At least 10 cm 5-2 6. Connect the pedal cord. 6-1 Insert the pedal cord plug to the [TO PEDAL] jack from the rear. 6-2 Securely wind the cord holder around the pedal cord. The cord holder is attached to D. 6-3 Use a vinyl tie (Step 1-1) to take up any slack in the pedal cord. A D B E Align the dowels on D and E with the corresponding holes on the bottom of A. 32 YDP-S34 Owner's Manual