Yamaha YHT-15 Quick Connection Guide - Page 11

YHT-15 QUICK- CON N ECT GUIDE PROGRAMMING THE REMOTE CONTROL (RAV141) Indicator LED For Code Setup DVD LD RECEIVER CD TAPE TUN SET UP PRG+ PLAY UP TIME/ LEVEL- DLY/CNT/REAR REW LEFT PAUSE MENU POWER TIME/ LEVEL+ FF RIGHT TV INPUT PRG- STOP DOWN - DIR A SKIP/CHAPTER DECK A/B A/B/C/D/E +100 + DIR B EFFECT ON/OFF DISC SKIP PRESET + CH REC/ PAUSE SLEEP TV MUTE TV VCR VOL - CBL/ DSS INPUT SELECT CD TAPE 12 TUNER 3 PHONO DVD/LD VCR 456 TV/DBS 789 Components (Devices) Turns On Component's Power POWER ON 1. Load the supplied batteries into the remote control. 2. Aim the unit at the receiver, press RECEIVER/TUN, and then press POWER. 3. The receiver should turn on. SETTING UP YOUR TV 1. Look up a setup code for your television set (see pages 12 and 13). 2. Turn on the television set. Components (Devices) 3. On the remote control, press TV; then press and hold SETUP until the indicator LED flashes twice. 4. Using the keypad, enter the three-digit number. The indicator LED will flash twice after your entry. Use Keypad To Enter Setup Codes 5. The TV's controls are now assigned to the remote control buttons (see Quick Reference Card for use). To test the code, press TV and then POWER. If the TV does not respond, try an alternate code. SETTING UP YOUR CABLE BOX (OR DSS) 1. Look up a setup code for your cable box or digital satellite system (see pages 11 and 12). 2. Turn on the cable box (or DSS). ENT 0 TEST DISP RAV141 VZ44810 3. On the remote control, press CBL/DSS; then press and hold SETUP until the indicator LED flashes twice. 4. Using the keypad, enter the three-digit number. The indicator LED will flash twice after your entry. The YHT-15 Home Theater package includes the RAV141 Remote Control. It comes pre-programmed with factory codes to control your R-V503 receiver and most Yamaha audio components. To program other brands of components (i.e., TV, VCR, etc.) or if your Yamaha unit does not respond, you will need to program the remote control with the manufacturer's codes (listed on pages 11 through 14). NOTE: The RAV141 is designed to control most major brands of audio and video components. For other units, use the original remote control supplied with the product. Perform the procedure for each component you own. At the end of step 5, the remote control's processor will automatically assign the selected component's control functions to its own buttons, ready for your use. NOTE: To clear the RAV141's memory and return it to the factory codes, press and hold SETUP; then enter 9 8 1. 5. The unit's controls are now assigned to the remote control buttons (see Quick Reference Card for use). To test the code, press CBL/DSS and then POWER. If the unit does not respond, try an alternate code. SETTING UP YOUR VCR 1. Look up a setup code for your VCR (see pages 13 and 14). 2. Turn on the VCR. 3. On the remote control, press VCR; then press and hold SETUP until the indicator LED flashes twice. 4. Using the keypad, enter the three-digit number. The indicator LED will flash twice after your entry. 5. The VCR's controls are now assigned to the remote control buttons (see Quick Reference Card for use). To test the code, press VCR and then POWER. If the unit does not respond, try an alternate code. continued on the next page... 9