Yamaha YHT-30 Quick Connection Guide - Page 10
Locations Of Tv Learning Buttons
View all Yamaha YHT-30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
YHT-30 QUICK- CON N ECT GUIDE LOCATIONS OF TV LEARNING BUTTONS CLEAR LEARN MACRO TRANSMIT ⁄LEARN REC⁄ PAUSE A⁄B TAPE CD HOW TO PROGRAM TV REMOTE FUNCTIONS To program basic functions of the TV remote, we suggest you learn functions into all the shaded buttons shown in the illustration on the left: 1. On the RAV120, slide the MEMORY switch to position B. VOLUME UP TUNER A DIR B STOP DISC VCR DVD⁄LD T V⁄ DBS REC⁄ PAUSE 2. Aim the TV remote control transmitter (usually located at the top) at the top of the RAV120. Slide MEMORY Switch To B RAV120 With Lid Open CLEAR TV Remote Control LEARN A DIR B VOLUME DOWN CHANNEL KEYPAD (0~9) CHANNEL DOWN TV POWER PRO LOGIC 1 ENHANCED 2 CONCERT VIDEO 3 MONO MOVIE 4 STADIUM 5 DISCO 6 ROCK HALL 7 8 9 TEST 0 T IME ⁄ LE V EL DELAY CENTER REAR SWFR V-AUX PHONO EFFECT SLEEP 2CH/6CH SYSTEM P O W ER TV MASTER VOLUME CHANNEL UP A⁄B MACRO 2~ 4 " TRANSMIT ⁄LEARN TAPE CD TUNER VCR TV INPUT 3. On the RAV120, use a paper clip or mechanical pencil to press LEARN. The TRANSMIT/LEARN red LED will start to flash. NOTE: If there is no operation for about 30 seconds after a button is pressed, the TRANSMIT/LEARN LED will flash repeatedly. If this occurs, restart from step 3. VCR OFF 4. On the RAV120, press and hold the button to which you want to assign the function until the TRANSMIT/LEARN LED turns on. REMOTE CONTROL TRANSMITTER RAV120 With Lid Open 5. On the TV remote, press and hold the button for the corresponding function until the TRANSMIT/ LEARN LED turns off. NOTE: If a TV remote function has two buttons and the RAV120 has one, then press both TV remote buttons simultaneously to learn the function into the RAV120. 6. The RAV120's TRANSMIT/LEARN red LED will flash slowly after the function is learned. NOTE: If the RAV120's TRANSMIT/LEARN red LED flashes rapidly, the function has not been learned. Repeat steps 5 and 6 to program the function. 7. Continue programming until you have learned functions into all of the shaded buttons. 8. Press LEARN. 9. To test programming, press TV (power) to turn on the TV. Then press each button you've programmed. Repeat steps 1 through 8 for any function that does not respond. 10