Yamaha YHT-800 Quick Connection Guide - Page 12

YHT-800 QU I C K -CONNECT GUIDE OPERATING THE UNIVERSAL REMOTE CONTROL OVERVIEW The universal remote control will control up to nine different types of components each of which becomes active when you press a selection ( except TV which has priority and TV function buttons are always active). We can only briefly describe some functions here, and we encourage you use the HTR-5550 Owner's Manual to gain additional experience with this powerful unit. PLAYING A VIDEOCASSETTE 1. Aim the remote control at the HTR-5550, press SYSTEM POWER to turn the receiver on. Press VCR as the input for the receiver. 3. Load a DVD into the DVD player. 4. Aim the remote control at the DVD player, and press (forward button) to start play. NOTE: The DVD player's controls are now assigned to the remote control buttons, since DVD was the last selected component. RESETTING THE REMOTE CONTROL TO FACTORY CODES You can reset the remote control to factory codes for all components or a desired component, as follows: RESETTING CODES FOR ALL COMPONENTS 1. Press any component selector. 2. Aim the remote control at the TV, press the TV POWER to turn the television on. 2. Press CODE SET using a ballpoint pen or similar object. The TRANSMIT indicator LED will flash twice. 3. Aim the remote control at the VCR, press VCR to select the component, and then press AV POWER to turn the VCR on. Put a tape in the VCR, press (forward button) to start play. 3. Using the keypad, enter the code "9990". 4. The indicator LED will flash twice to confirm all codes have been reset to factory values. If the LED does not flash twice, repeat steps 1 through 3. NOTE: At this point, the VCR controls are assigned to the remote control, since VCR was the last selected component. RESETTING CODES FOR A DESIRED COMPONENT 1. Press a component selector button that matches the component you wish to reset to factory codes. 2. Press CODE SET. The TRANSMIT indicator LED will flash twice. PLAYING A DVD 1. Aim the remote control at the HTR-5550, press SYSTEM POWER to turn the receiver on. Press DVD as the input for the receiver. 2. Press DVD and then press AV POWER to turn the DVD player on. NOTE: If the DVD player is plugged into the switched outlet (on the back of the receiver) and its power switch AC was already engaged, the unit will come on each time the receiver is powered on. 3. Using the keypad, enter the code "0000". 4. The indicator LED will flash twice to confirm all codes have been reset to factory values. If the LED does not flash twice, repeat steps 1 through 3. 5. For your convenience, the following reference chart lists the factory codes: Component Component Selector Button Code CD MD/CD-R TUNER DVD CD MD TUNER DVD 0005 Yamaha 0024 Yamaha 0003 Yamaha 0098 Yamaha ©2002 YAMAHA ELECTRONICS CORPORATION, USA 6660 Orangethorpe Avenue, Buena Park, CA 90620 PH: (714) 522-9105; FAX: (888) 435-7922 http://www.yamaha.com 12