Yamaha YM-2400R Owner's Manual - Page 18

YM-410D ASSEMBLY v Insert the rail (1) into the frame ends of the legs. 4-1. Insert the outer rail (1) in the same way as the inner rails (2), (3) and (4). A mark "A" is printed on the large end face of the rail (1) and the groove section of the frame end of the large end leg. b Set the tone bars. 5-1. While adjusting the long frame, engage the rail clamp on rail (2) and rail (3) with rail (1) and rail (4), respectively. Rail clamp Rail (1) Rail clamp Rail (4) Rail (2) Rail (3) 5-2. Set the natural tone bars first. With one person holding the suspension cord on the bass side and the other holding the suspension cord on the treble side securely with both hands, gently place the tone bars on the rails. Align each tone bar individually and hook its cord onto the corresponding tone bar post. After confirming that the cord is secured to every post, fix the tone bars by pulling the right and left cords forward from the large end side and hooking the two springs into each other. * When setting the tone bars, use care not to cause any damage to them. Small end Large end Suspension cord Suspension cord n Once again, confirm that all screws are tightened firmly. 38 Springs