Yamaha YSP-3000SL Owners Manual - Page 40
Installing the IntelliBeam microphone, Place the IntelliBeam microphone on a flat
View all Yamaha YSP-3000SL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
AUTO SETUP (IntelliBeam) Installing the IntelliBeam microphone The supplied IntelliBeam microphone collects and analyzes the sound that this unit produces in your actual listening environment. Follow the procedure below to connect the IntelliBeam microphone to this unit and make sure that the IntelliBeam microphone is placed in a proper location and that there are no large obstacles between the IntelliBeam microphone and the walls in your listening room. Notes • After you have completed the AUTO SETUP procedure, be sure to disconnect the IntelliBeam microphone. • The IntelliBeam microphone is sensitive to heat. - Keep it away from direct sunlight. - Do not place it on top of this unit. • Do not connect the IntelliBeam microphone to an extension cable as doing so may result in an inaccurate sound optimization. • An error may occur during the AUTO SETUP procedure if the IntelliBeam microphone is not properly placed in your listening room. To avoid the possibility of an error: - Do not place the IntelliBeam microphone to the extreme right or left from the center of this unit. - Do not place the IntelliBeam microphone within 1.8 m (6.0 ft) from the front of this unit. - Do not place the IntelliBeam microphone more than 1 m (3.3 ft) upper or lower from the center height of this unit. • Make sure that there are no obstacles between the IntelliBeam microphone and the walls in your listening room as these objects obstruct the path of sound beams. However, any objects that are in contact with the walls will be regarded as a protruding part of the walls. • The best possible results are achieved if the IntelliBeam microphone is placed at the same height as your ears would be when you are seated in your listening position. However, if this is not possible, you can manually fine-tune the sound beam angle and balance the sound beam output levels using MANUAL SETUP (see page 72) once the AUTO SETUP procedure is completed. • If a subwoofer with adjustable volume and crossover/high-cut frequency controls is connected to this unit, set the volume between 10 and 12 o'clock as viewed on a conventional clockface and set VOLUME CROSSOVER HIGH CUT the crossover/high-cut frequency to the maximum. MIN MAX MIN MAX Subwoofer 1 Press STANDBY/ON to turn off the power of this unit. STANDBY/ON or STANDBY/ON Front panel Remote control 2 Connect the supplied IntelliBeam microphone to the INTELLIBEAM MIC jack on the front panel. 3 Place the IntelliBeam microphone on a flat level surface more than 1.8 m (6.0 ft) from the front of the unit and within 1 m (3.3 ft) upper or lower from the center height of the unit with the IntelliBeam microphone facing upward at your normal listening position. Note Be sure to place the IntelliBeam microphone on an imaginary center line drawn from this unit. y You may want to use the supplied cardboard microphone stand to affix the IntelliBeam microphone at the same height as your ears would be when you are seated in your listening position. INTELLIBEAM MIC IntelliBeam microphone More than 1.8 m (6.0 ft) Within 1 m (3.3 ft) upper or lower from the center height Cardboard microphone stand Sofa 36 En