Zanussi ZDC37200W Product Manaul - Page 5
Green and Yellow - Earth - parts
View all Zanussi ZDC37200W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
carpets, strips of wood or similar. This might cause heat built-up which would interfere with the operation of the appliance. Important! • The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The appliance must therefore not be installed on floors which are not resistant to high temperatures. • When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. • Should the appliance be moved, it must be transported vertically. • The appliance must not be installed behind the lockable door, a sliding door a door with a hinge on the opposite side to that of the appliance in such a way that a full opening of the dryer is restricted. Ensure min. 5cm free space around the appliance. Removing transport safety packaging Caution! Before use all parts of the transport packaging must be removed. 3. Remove foil hose and polystyrene padding from the machine. Electrical connection Details on mains voltage, type of current and the fuses required should be taken from the rating plate. The rating plate is fitted near the loading aperture (see "Product description" chapter). Connect the machine to an earthed socket, in accordance with current wiring regulations. Warning! The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions. Should the appliance power supply cable need to be replaced, this must be carried out by an authorised service engineer or a qualified electrician. . The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved BS 1363/A fuse must be used. 4 1. Open loading door 2. Pull off adhesive strips from inside machine on top of drum. www.zanussi.com 3 1 2 The wires in the mains lead are coloured in accordance with the following code: 1 Blue - Neutral 2 cord clamp 3 Brown - Live 4 Green and Yellow - Earth The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow. 5