Zenith P50W38 Service Manual - Page 17

ADJUSTMENT INSTRUCTIONS 2) After turning the RV401, voltage of D.M.M adjustment as 6-3. White Balance Adjustment same as Vs voltage which on the label of the PCB Right/Top. (Deviation : ±0.5V) O Operate the Zero-calibration of the CA-100, then stick sensor to PDP module surface when you make adjustment. P805 Va O For manual adjustment, it is also possible by the following sequence. DMM +- GND NC Vs P804 RV401 Vs ADJ RV601 Va ADJ (1) Select WHITE PATTERN of HEAT RUN mode by pressing POWER ON KEY on service remote control then operate HEAT RUN more than 15 minute. (2) Supply 216Gray Level, 50% size length and breadth signal to RGB input. (Refer to Fig 2) (3) W/B adjustment must be adjusted only High Light and then save the adjustment value with Y Key. (4) To adjust High Light, stick sensor to 216 Gray Level (or 105115 Cd/m2) Pattern, press ADJ Key on R/C for adjustment and press T, U on R/C in adjustment mode to select R-L or GL, press VOL +, - Key and adjust it until color coordination becomes as below. X: 0.275±0.003, Y: 0.280±0.003 Color temperature: 11,500°K±500°K Connection Diagram of Power Adjustment for Measuring 6. White Balance Adjustment 6-1. Required Equipment Color analyzer (CA-100 or same product) 6-2. Connection Diagram of Equipment for Measuring (Manual Adjustment) R-L 70 G-L 70 R-M 128 G-M 128 R-H 216 G-H 216 High Light 216 Gray Level 105~115Cd/§‡ COLOR ANALYZER TYPE;CA-100 RGB Signal Input PDP MONITOR Window MSPG-2100 or MSTG-5200 Connection Diagram of Manual Adjustment(High Light) (5) Exit adjustment mode using Y Key. 6-4. RS-232C Communication Protocol & Transmission Parameter (1) Communication Parameter 1) Communication Protocol & Transmission Parameter : Communication Parameter - Data Length: 8bit - Parity: none - Stop bit: 1bit - Band Rate: 115200bps(UART) - Communication code: ASCII code [ Using Crossed(reverse) Cabel 2) Transmission $ Receiving Protocol Transmission[Command1][Command2][][Set ID][][Data][Cr] * [Command1]: First command to control PDP Monitor (j or k) * [Command2]: Second command to control PDP Monitor (a,b,c,....) * [Set ID]: You can adjust the set ID to choose desired monitor ID number in special menu. Adjustment range is 1 ~ 99. When selecting Set ID '0', every connected set is controlled. [ Set ID is indicated as decimal (1~99) on menu and as Hexa decimal (0x0~0x63) on transmission/receiving protocol. * [Data] : To transmit command data. [ Transmit 'FF' data to read status of command. - 17 -