ZyXEL SBG3300-N Series User Guide - Page 60
The 802.1x Screen
View all ZyXEL SBG3300-N Series manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Chapter 5 Broadband Click Network Setting > Broadband > Advanced to display the following screen. Figure 28 Network Setting > Broadband > Advanced The following table describes the labels in this screen. Table 13 Network Setting > Network Setting > Advanced LABEL DESCRIPTION PTM over ADSL Select Enable to use PTM over ADSL. Since PTM has less overhead than ATM, some ISPs use PTM over ADSL for better performance. Annex M You can enable Annex M for the Device to use double upstream mode to increase the maximum upstream transfer rate. PhyR US Enable or disable PhyR US (upstream) for upstream transmission to the WAN. PhyR US should be enabled if data being transmitted upstream is sensitive to noise. However, enabling PhyR US can decrease the US line rate. Enabling or disabling PhyR will require the CPE to retrain. For PhyR to function, the DSLAM must also support PhyR and have it enabled. PhyR DS Enable or disable PhyR DS (downstream) for downstream transmission from the WAN. PhyR DS should be enabled if data being transmitted downstream is sensitive to noise. However, enabling PhyR DS can decrease the DS line rate. Enabling or disabling PhyR will require the CPE to retrain. For PhyR to function, the DSLAM must also support PhyR and have it enabled. Apply Click Apply to save your changes back to the Device. Cancel Click Cancel to return to the previous configuration. 5.6 The 802.1x Screen You can view and configure the 802.1x authentication settings in the 802.1x screen. Click Network Setting > Broadband > 802.1x to display the following screen. Figure 29 Network Setting > Broadband > 802.1x 60 SBG3300-N Series User's Guide