eMachines T6211 NG3 Hardware Reference - Page 171
Slide the old drive out of the bay., the two screws on one side of the bay are shown below.
View all eMachines T6211 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 171 highlights
CHAPTER 13: Adding and Replacing Components www.emachines.com 4 Remove the screw that secures the hard drive bay to the case. Screw 5 Slide the hard drive bay away from the system board and toward the open side of the case, then remove the hard drive bay from the case. 164 6 If you are adding a new drive, go to Step 9. If you are replacing an existing drive, go to the next step. 7 Remove the four screws that secure the hard drive to the drive bay. (Only the two screws on one side of the bay are shown below.) Screws 8 Slide the old drive out of the bay. 9 Slide the new drive into the drive bay. 10 Use the four screws you removed previously to secure the hard drive to the hard drive bay.
CHAPTER 13: Adding and Replacing Components
www.emachines.com
164
4
Remove the screw that secures the hard drive bay to the case.
5
Slide the hard drive bay away from the system board and toward the open
side of the case, then remove the hard drive bay from the case.
6
If you are adding a new drive, go to
Step 9
. If you are replacing an existing
drive, go to the next step.
7
Remove the four screws that secure the hard drive to the drive bay. (Only
the two screws on one side of the bay are shown below.)
8
Slide the old drive out of the bay.
9
Slide the new drive into the drive bay.
10
Use the four screws you removed previously to secure the hard drive to
the hard drive bay.
Screw
Screws