iRobot Looj 125 Product Manual - Page 10

 Storing Looj Store iRobot Looj in a cool, dry place. After charging store Looj and its battery between 50˚ and 80˚ F (10˚-26˚ C). Excessive heat or cold may reduce battery life and product performance. For best results, we recommend removing both the battery pack from the robot and the batteries from the remote control handle when the product is stored.  Troubleshooting Refer to the chart below to resolve Looj's problem. If the problem is not resolved, visit www.irobot.com/support (page 20). Observation Remote transmission light does not light up on the remote. Robot is not responding to the remote control handle. Auger will not insert into robot. Auger stops spinning and loud clicking sound is heard. Auger is spinning but robot is not moving. Clicking sound is heard. Likely Cause What to do Batteries were inserted incorrectly Check the battery orientation or replace with or have depleted. Power may not fresh batteries. Switch the remote power be on. button to the "on" position. Robot power is off or there is radio interference between the remote control handle and robot. Check to see that both power buttons are on and both robot and remote control handle lights are flashing when a remote button is pressed. If not, try to improve reception by raising the remote control handle above the height of the gutter while operating. Insertion hole is clogged. Clean out hole with toothpick or forced air. Clutch has slipped on Auger. Robot movement has stopped to protect the robot track motors. The clutch has slipped on the robot track wheels. Immediately turn off the auger and back up the robot away from any debris. Try spinning the auger in a clear area to test it. Retrieve robot, clean the wheels and test it on the ground to make sure it is operating properly before placing back into the gutter. Indicator Lights Robot Power Light Solid Red Blinking Red Solid Green What it means Battery is low. Turn off auger immediately and recharge battery. Battery is low and robot is receiving data (commands) from the remote. Turn off auger immediately and recharge battery. Power is on, battery level is ok. Remote Transmission Light Solid Green Blinking Green What it means Power is on. Remote control is sending data (commands) to the robot. 18 iRobot Looj Owner's Manual www.irobot.com 19