2006 BMW 7 Series Owner's Manual - Page 100

Technology for comfort, convenience and safety 3. Select the menu item and press the controller: > "Zoom": At higher speeds, the image is zoomed in. > "Curve mode": Depending on the steering angle and other parameters, the image section follows the course of the road to some degree. > "Full screen": The image is shown on the entire Control Display. > "Contrast": The contrast of the screen can be adjusted, refer to page 170. > "Brightness": The brightness of the screen can be adjusted, refer to page 170. The "Curve mode" can only be activated with the "Zoom" function switched on. With "Full screen" activated, "Curve mode" and "Zoom" cannot be selected.< The settings are stored for the remote control currently in use. To exit the menu: The image will automatically disappear after approx. 5 seconds, or select the return arrow and press the controller to exit sooner. To minimize icing the camera lens is automatically heated. However, it may be necessary to clean the camera lens manually under severe weather conditions. When doing so, cautiously remove any debris, ice or snow. To avoid damage to the lens, do not use sharp or abrasive instruments to clean ice, snow, or dirt off the lens. When the windshield is cleaned with the headlamps on, the camera lens area is automatically sprayed as well. Refer to page 65. Cleaning camera The function of the camera may be affected by heavy rain and fog, dirt, snow or ice on the lens. When this occurs, the displayed image on the Control Display may become gray. 98 Online Edition for Part No. 01 41 0 012 254 - © 02/06 BMW AG