1996 Buick Skylark Owner's Manual - Page 246

2. Push it back in all the way, wait three seconds and then pullit back out again. How to Add Fluid Refer to the Maintenance Schedule to determine what kind of transaxle fluid to use. See "Recommended Fluids and Lubricants" the Index. in 3. Check both sides of the dipstick, and read the . lower level. The fluid level must bein the cross-hatched area. If the fluid level is low, add only enough the proper of fluid to bringthe level into the cross-hatched area,on the dipstick. 1. Pull out the dipstick. 2. Using a long-neck funnel, add enough fluid at the dipstick holeto bring it to the proper level. doesn't It (.L. take muchfluid, generally less than a pint 0 5 ) Don't overjill. We recommend you use only fluid labeled DEXRON@-III,because fluid with that label is made especially your automatic transaxle. for Damage caused by fluid other than DEXRON@-III is not covered by your new vehicle warranty. 4. If the fluid level is in the acceptable range, push the dipstick backin all the way. After addingfluid, recheck the fluid levelas described under "How to Check." When the correct fluid level obtained, push the is all dipstick back in the way. 6-19