1998 Buick Riviera Owner's Manual - Page 154

RECALL: Press this button briefly to recall station the being played or to display clock. To change whatis the normally shown onthe display (stationor time), press the RECALL button until you the display you want, see then holdthe RECALL button untilthe display flashes. If you press the button when the ignition off, the clock is will show for a few seconds. Finding a Station AM-FM: Press this button to switch between AM, FM1 and FM2.The display shows your selection. TUNE: Press the up or down arrow to choose radio stations. 1. Turn the radioon. 2. Press AM-FM to select the band. 3. Tune in the desired station. the 4. Press TONE to select setting you prefer. SEEK: Press the up or down arrow to to the next go higher or lower station and stay there. sound will The mute while seeking. SCAN: Press one of the SEEK arrowsfor two seconds and SCAN will appear the display. Use SCAN to on listen to stations a few seconds. for The radio willgo to a station, stop a few seconds, then go on the next for to station. Press one the SEEK arrows again to stop of scanning. The sound will mute while scanning. PUSHBUTTONS: The six numbered pushbuttonslet you return to your favorite stations. You can set up to 18 stations (six AM, six FM1 and six FM2). Just: 5. Press and hold one the six numbered buttons.The of sound will mute. When it returns, release button. the Whenever you press that numbered button, the station you set will return and the tone you selecte will be automatically selected that button. for 6. Repeat the stepsfor each pushbutton. P SCAN: Press this button to listen to eachyour of preset stationsfor a few seconds.The radio willgo to the first preset station, stop a few seconds, then go for on to the next preset station. Press P SCAN again to stop scanning. If a preset station has weak reception, the radio will not stop at the preset station. AUTO SET Press this button and the system will seek and set the12 strongest FM or the 6 strongest AM stations on your preset buttons. AUTO SET will flash while seeking and will remain on until this function is complete. To return to the stations you manually set, press AUTO SET again. 3-11