2007 Buick Lucerne Owner's Manual - Page 13

Memory Seat and Mirrors Your vehicle may have the memory package. To recall your memory positions, the vehicle must be in PARK (P). Press and release either button 1 or button 2 corresponding to the desired driving position. The seat and outside mirrors will move to the position previously stored for the identified driver. You will hear a single beep. If you use the remote keyless entry transmitter to enter your vehicle and the remote recall memory feature is on, automatic seat and mirror movement will occur. See "MEMORY SEAT RECALL" under DIC Vehicle Customization on page 231 for more information. To stop recall movement of the memory feature at any time, press one of the power seat controls, memory buttons, or power mirror buttons. If something has blocked the driver's seat while recalling a memory position, the driver's seat recall may stop working. If this happens, press the appropriate control for the area that is not recalling for two seconds, after the obstruction is removed. Then try recalling the memory position again by pressing the appropriate memory button. If the memory position is still not recalling, see your dealer for service. The controls for this feature are located on the driver's door panel, and are used to program and recall memory settings for the driver's seat and the outside mirrors. To save your positions in memory, do the following: 1. Adjust the driver's seat, including the seatback recliner and lumbar, and both outside mirrors to your preferred position. 2. Press and hold button 1 until two beeps sound through the driver's side front speaker to let you know that the position has been stored. A second seating and mirror position can be programmed by repeating the above steps and pressing button 2 for a second driver. 13