2012 Buick Regal Owner Manual - Page 364

10-90 Vehicle Care Keyless Access With the brake pedal not applied, press and hold the ENGINE START/ STOP button for more than five seconds. This will place the vehicle in the Service Only Mode. Proceed as follows: 1. Press MENU (C) on the turn signal lever until Vehicle Information Menu is displayed. Use w / x (Thumbwheel) (B) to scroll through the menu items until Jump Start is displayed. 2. Press SET/CLR (A) to activate the jump start. 3. The system will then ask for confirmation. If yes is selected, the jump start will begin and the display will show JUMP START ACTIVE WAIT TO START. 4. When the jump start is complete, the display will show JUMP START COMPLETE ATTEMPT START. If the vehicle is started, the on￿board jump start function will be automatically disabled. If the vehicle cranks but does not start, the procedure may be repeated again. If the vehicle start is still unsuccessful, the jump start can be attempted using the following jump starting procedure under "Jump Starting (with or without eAssist)." On￿board jump starting may be unavailable due to the 12-volt battery charge level, the eAssist battery charge level, power capability, or an issue with the eAssist system. In these cases, the display will not be available because of the power issue, or the DIC will display JUMP START DISABLED SEE OWNERS MANUAL. Key Access Place the ignition key in the run position and proceed as follows: 1. Press MENU (C) on the turn signal lever until Vehicle Information Menu is displayed. Use w / x (Thumbwheel) (B) to scroll through the menu items until Jump Start is displayed. 2. Press SET/CLR (A) to activate the jump start. 3. The system will then ask for confirmation. If yes is selected, the jump start will begin and the display will show JUMP START ACTIVE WAIT TO START. 4. When the jump start is complete, the display will show JUMP START COMPLETE ATTEMPT START.