1999 Chevrolet Monte Carlo Owner's Manual - Page 105

yellowblue Installation 1. Move the driver's seat to its most rearward position. 2. Place the driver's side floor mat in the vehicle with the rear of the mat against the left (outboard) front edge of the seat track mounting bracket (see view A). 3. Use a screwdriver to screw the locator post into the vehicle's carpeting. Press down while turning to allow the locator to pierce the floor carpet. The locator will not screw down tightly, but will rotate freely when installed properly. Usage Auxiliary Power Connection Your vehicle is equipped with auxiliary power leads. These leads can be used to power aftermarket electrical equipment added to your vehicle. D To remove the mat, pull up on the rear of the mat to unsnap it from the locator post (see view B). D To re-install the mat, align the grommet in the mat over the locator post and push down to snap the mat into place (see view B). They are located on the passenger's side of the vehicle, below the glove box and behind what is referred to as a "hush panel." For additional information on accessing these leads and electrical hookup, please refer to the service manual. 2-43