2000 Chevrolet Tahoe Owner's Manual - Page 296

Replace the jack, tools and spare tire lock. For Utility Models: 1. Put the tool kit with the jack tools and gloves in the tool bag and place in the retaining dip under the driver's side second seat. 2. Tighten down with the the wing nut. 3. Then, assemble wheel chocks and bottle jack together with the wing nut and retaining hook. 4. Position behind the jack storage cover in the left rear side panel just below the speaker and tighten, adjusting clockwise until the jack is secured tight in mounting bracket. For Suburban/Yukon XL Models: 1. Return the tool kit (jack tools and gloves) to the tool bag. 2. Assemble wheel chocks and bottle jack together with the wingnut and retaining hook. 3. Position behind the jack storage cover in the left rear side panel just below the speaker and tighten, adjusting clockwise until the jack is secured tight in mounting bracket. 4. Use the retaining clip to fasten the tool kit on the stud in the storage compartment in the rear left trim panel and turn wingnut clockwise to secure. 5. Return the storage tray. See the jacking label for further information. A. Hoist Assembly B. Wheel Wrench C. Jack Handle Extensions D. Hoist Shaft E. Valve Stem, Pointed Up F. Flat or Spare Tire G. Tire Retainer H. Hoist Cable To store the tools, follow these procedures. 5-30