2003 Chevrolet Silverado 2500 Pickup Owner's Manual - Page 98
2003 Chevrolet Silverado 2500 Pickup Manual
Page 98 highlights
To enter the program mode you need to do the following: 1. Beginning with the ignition in LOCK. Pull back on the turn signal/multifunction lever all the way toward you until flash-to-pass is activated, and hold it while you perform the next step. The following is a list of the available programming options: e All doors IocWOnly the driver's door unlocks: Press the lock side of the power door lock switch on the door panel once and then the unlock side once. 2. Turn your key to RUN and LOCK twice. Then, with the key in LOCK, release the turn signaVmultifunction lever. Once you do this, you will hear the lock mechanism lock and unlock. 3. You are now ready to program the automatic door locks. Select one of the following four programming options and follow the instructions. You will have thirty seconds to complete programming. If you exceed the thirty-second limit, the locks will automatically lock and unlock to indicate you have left the program mode. If this occurs, repeat the procedure beginning with Step 1. You can exit the program mode any time by turning the ignition to RUN (the locks will automatically lock and unlock to indicate you are leaving the program mode.) If the lock/unlock switches are not pressed while in the programming mode, the automatic lock/unlock setting will not be modified. e All doors IocWAll doors unlock: Press the lock side of the power door lock switch on the door panel once, and then the unlock side twice. All doors locWNone of the doors unlock: Press the lock side of the power door lock switch on the door panel once, and then the unlock side three times. e e f the doors unlock: Press No doors IocWNone o the lock side of the power door lock switch on the door panel twice. This turns off the automatic lock feature. For more information, see your dealer. 2-1 1