2008 Chevrolet Cobalt Owner's Manual - Page 178
2008 Chevrolet Cobalt Manual
Page 178 highlights
Finding a Station BAND: Press this button to switch between FM1 and FM2, AM, or XM™ (if equipped). The selection displays. f (Tune): Turn to select radio stations. information such as: Channel, Song, Artist, and CAT (category) can display. Continue pressing to highlight the desired label, or press the pushbutton positioned under any one of the labels and the information about that label displays. While information is not available, No Info displays. Press the arrows to go to the previous or to the next station and stay there. To scan stations, press and hold either arrow for a few seconds until a beep sounds. The radio goes to a station, plays for a few seconds, then goes on to the next station. Press either arrow again to stop scanning. The radio only seeks and scans stations with a strong signal that are in the selected band. ©SEEK ¨: Setting Preset Stations (Radio with CD (Base Only)) Up to 18 stations (six FM1, six FM2, and six AM), can be programmed on the six numbered pushbuttons, by performing the following steps: 1. Turn the radio on. 2. Press BAND to select FM1, FM2, or AM. 3. Tune in the desired station. 4. Press and hold one of the six numbered pushbuttons for three seconds until a beep sounds. When that pushbutton is pressed and released, the station that was set, returns. 5. Repeat Steps 2 through 4 for each pushbutton. 4(Information) (Radio with CD (Base)): Press to switch the display between the radio station frequency and the time. While the ignition is off, press this button to display the time. and RDS Features): Press to display additional text information related to the current FM-RDS or XM™ station, or MP3 song. A choice of additional 4(Information) (XM™ Satellite Radio Service, MP3, 3-60