2011 Chevrolet Colorado Extended Cab Owner's Manual - Page 115

Instruments and Controls Move the band to one of the following positions: 5-3 Windshield Washer Compass Calibration The compass may need calibration if: . 8 (Mist): Use for a single wipe, move the band to 8 and then release it. For several wipes, hold the band on 8 longer. { WARNING In freezing weather, do not use the washer until the windshield is warmed. Otherwise the washer fluid can form ice on the windshield, blocking your vision. CAL is displayed while driving in the vehicle. After approximately five seconds, the display does not show a compass heading, N for North, for example, there may be a strong magnetic field interfering with the compass. Interference can be caused by a magnetic antenna mount, magnetic note pad holder, or a similar magnetic item. The compass does not display the correct heading and the compass zone variance is set correctly. . N (Adjustable Interval Wipes): For adjustable interval wipes, turn the band up for more frequent wipes or down for less frequent wipes. Use for slow wipes. Turn the band to the first solid position past the delay settings. 6 (Low Speed): 1 (High Speed): Use for fast wipes. Turn the band to the second solid position past the delay settings. 9 (Off): Use to turn the wipers off. Clear snow and ice from the wiper blades before using them. If frozen to the windshield, carefully loosen or thaw them. Damaged wiper blades should be replaced. Q L (Washer Fluid): Push the paddle on top of the multifunction lever to spray washer fluid on the windshield. The wipers will clear the window and then either stop or return to your preset speed. . Compass Compass Operation Press Y b or depending on the mirror, press O once to turn the display on or off. To calibrate, CAL must be displayed in the mirror compass windows. If CAL is not displayed, press and hold Y b / O for several seconds or until CAL is displayed.