2014 Chevrolet Express 3500 Passenger Owner Manual - Page 226

9-36 Driving and Operating The cruise control light on the instrument cluster comes on after the cruise control has been set to the desired speed. 1. Press the Increasing Speed While Using Cruise Control If the cruise control system is already activated, . +RES (Resume/Accelerate): Press briefly to make the vehicle resume to a previously set speed, or press and hold to accelerate. If cruise control is already active, use to increase vehicle speed. SET− (Set/Coast): Press briefly to set the speed and activate cruise control, or press and hold to decelerate. If cruise control is already active, use to decrease vehicle speed. I button. 2. Get up to the desired speed. 3. Press the SET− button on the steering wheel and release it. 4. Remove foot from the accelerator. Resuming a Set Speed If the cruise control is set at a desired speed and then the brakes are applied, the cruise control is disengaged without erasing the set speed from memory. Once the vehicle speed reaches about 40 km/h (25 mph) or more, briefly press the +RES button on the steering wheel. The vehicle returns to the previous set speed. . Press and hold the +RES button on the steering wheel until the desired speed is reached, then release it. To increase vehicle speed in small increments, briefly press the +RES button. Each time this is done, the vehicle goes about 1.6 km/h (1 mph) faster. [ (Cancel): Press to disengage cruise control without erasing the set speed from memory. Setting Cruise Control If the cruise button is on when not in use, it could get bumped and go into cruise when not desired. Keep the cruise control switch off when cruise is not being used. Reducing Speed While Using Cruise Control If the cruise control system is already activated: . Press and hold the SET- button on the steering wheel until the desired lower speed is reached, then release it. To slow down in small increments, briefly press the SET- button on the steering .