2006 Chrysler Crossfire Owner's Manual - Page 109
2006 Chrysler Crossfire Manual
Page 109 highlights
UNDERSTANDING YOUR INSTRUMENT PANEL 109 CAUTION! Continuing to drive with an overheated engine cooling system can cause damage to the engine or other components. 5. Fuel Gauge When the ignition is in the ON/RUN position, the pointer will show the level of fuel remaining in the tank. The arrow to the right of the gas pump symbol shows which side of the vehicle the fuel filler door is located on. 6. Turn Signal Indicators To signal minor directional changes, such as changing lanes, move the multifunction control lever to the point of resistance only and hold it there. The arrows will flash in unison with the corresponding exterior turn signal. To operate the turn signals continuously, move the multifunction control lever past the point of resistance up or down. The switch is automatically canceled when the steering wheel is turned to a large enough degree. The arrows in the instrument cluster will flash in unison with the respective exterior turn signal. 7. Electronic Stability Program (ESP) Indicator Light The yellow ESP indicator light in the speedometer dial comes on with the key in the ignition switch turned to the ON/RUN position. It should go out with the engine running. If the ESP indicator light flashes during acceleration, apply as little throttle as possible. While driving, ease up on the accelerator. Adapt your speed and driving to the prevailing road conditions, and do not switch off the ESP. 8. Speedometer The speedometer shows the vehicle speed in miles-perhour and/or kilometers-per-hour. 9. Tachometer This gauge shows engine speed in revolutions-perminute (RPM) times 1,000. The red markings on the tachometer indicate excessive engine speed. Ease off on the accelerator before reaching the red area. 4