2006 Chrysler PT Cruiser Owner Manual - Page 34

34 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 3. Test the flash lamps with LOCK feature while outside of the vehicle, by pressing the LOCK button on the key fob with the ignition in the LOCK position, and the key removed. NOTE: Pressing the LOCK button on the key fob, while you are in the vehicle, will activate the Security Alarm. Opening a door with the Security Alarm activated will cause the alarm to sound. Press the UNLOCK button to deactivate the Security Alarm. The "Flash Lights On Lock/Unlock" feature can be reactivated by repeating this procedure. To Program Additional Transmitters NOTE: If vehicle is equipped with the optional Electronic Vehicle Information Center (EVIC) in the instrument cluster, the transmitters may also be programmed through the EVIC display. Up to 8 transmitters can be programmed to your vehicle. To obtain additional transmitters, contact your authorized dealer. To program a transmitter (within 23-50 feet (7-15 meters) of the vehicle), perform the following procedure: 1. Gather every transmitter that is to be used with the vehicle including any transmitters that are currently programmed. 2. Enter Program Mode: Turn the ignition to the ON position, and using a currently programmed transmitter; press and hold the ЉUnlockЉ button on the transmitter. Continue to hold the "Unlock" button, wait at least 4 but no longer than 10 seconds, then press and hold the PANIC button for at least 1 second. Release both buttons simultaneously. 3. Program Each Transmitter: All transmitters to be used with your vehicle must be programmed as follows: Press and release the ЉLockЉ and ЉUnlockЉ buttons simultaneously, followed by a press and release of ANY button on each transmitter to be programmed. You will hear a chime when a transmitter has been successfully programmed.