2007 Chrysler Town & Country Owner's Manual - Page 178

3. Simultaneously press and hold both the HomeLink

button that you want to train and the hand-held trans-

mitter buttons.

Do not release the buttons until Step

Four has been completed.

NOTE:

Some gate operators and garage door openers

may require you to replace this Programming Step 3 with

procedures noted in the

²

Gate Operator/Canadian Pro-

gramming

²

section.

4. The HomeLink indicator light will flash slowly and

then rapidly after HomeLink successfully receives the

frequency signal from the hand-held transmitter. Release

both buttons after the indicator light changes from the

slow to the rapid flash.

5. Press and hold the just trained HomeLink button and

observe the indicator light or the EVIC display. If the

indicator light

stays on constantly, programming is

complete

and your device should activate when the

HomeLink button is pressed and released.

NOTE:

To program the remaining two HomeLink but-

tons, begin with

²

Programming

²

Step Two. Do not repeat

Step One.

NOTE:

If your hand-held transmitter appears to pro-

gram the universal transceiver, but your garage door

does not operate using the transmitter and your garage

door opener was manufactured after 1995, your garage

door opener may have a multiple security code system

(rolling code system). If your garage door is the “rolling

code” type, please proceed to the heading

“Program-

ming A Rolling Code System.”

Programming A Rolling Code System

1. At the garage door opener receiver (motor-head unit)

in the garage, locate the

²

learn

²

or

²

smart

²

button. This

can usually be found where the hanging antenna wire is

attached to the motor-head unit.

178

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

2007 Chrysler Town & Country Owner's Manual - Page 178

2007 Chrysler Town & Country Manual

Page 178 highlights