2008 Chrysler 300 Owner Manual SRT8 - Page 378
2008 Chrysler 300 Manual
Page 378 highlights
376 WHAT TO DO IN EMERGENCIES 25. Leave the parking brake set and the shift lever in PARK and start the engine. 26. Inflate the tire to the pressure indicated on the tire pressure label on the driver-side latch pillar by pressing the switch (3) on the air pump to I (ON) and watching the pressure gauge. When the tire pressure is set to the pressure indicated on the tire pressure label, press the AIR PUMP switch (3) to 0 (OFF) and turn off the engine. 27. Disconnect the TIREFIT system from the tire and reinstall the valve cap. 28. Place the sealant kit back in the trunk of the vehicle. Replace the sealant bottle at your nearest authorized MOPAR parts dealership. 29. Have the tire inspected at the earliest opportunity at an authorized dealer or tire service center. NOTE: • If a pressure of at least 19 psi (1.3 bar) cannot be maintained in the tire, the tire is too badly damaged. Do not attempt to drive the vehicle further. Call for assistance. • Do not operate the electric air pump for more than eight minutes to avoid overheating. The air pump may be used again once it has cooled down. • Replace the TIREFIT sealant bottle (5) once every four years to assure optimum operation of the system. • If TIREFIT is liquid, clean water and a damp cloth will remove the material from the vehicle or tire and wheel components. Once TIREFIT sealing material has dried, it can easily be peeled off and properly discarded. • Do not exceed 55 mph (90 km/h) until the tire has been inspected.