2008 Chrysler 300C Owner's Manual - Page 158
2008 Chrysler 300C Manual
Page 158 highlights
158 UNDERSTANDING THE FEATURES OF YOUR VEHICLE To Resume Speed: Push the lever up and release ("RESUME ACCEL"), and then remove your foot from the accelerator pedal. The EVIC will display the last set speed. WARNING! The Resume function should only be used if traffic and road conditions permit. Resuming a set speed that is too high or too low for prevailing traffic and road conditions could cause the vehicle to accelerate or decelerate too sharply for safe operation. This could cause an accident and/or serious injury. To Vary the Speed Setting: While ACC is set, you can increase the set speed by lifting and holding the lever up ("RESUME ACCEL"). If the lever is continually held, the set speed will continue to increase in 5 mph (Canada 10 km/h) increments until the lever is released. The increase in set speed is reflected in the EVIC display. Tapping the lever up once will result in a 1 mph (Canada 1 km/h) increase in set speed. Each subsequent tap of the lever results in an increase of 1 mph (Canada 1 km/h). While ACC is set, the set speed can be decreased by pushing and holding the lever down ("SET DECEL"). If the lever is continually held, the set speed will continue to decrease in 5 mph (Canada 10 km/h) increments until the lever is released. The decrease in set speed is reflected in the EVIC display.